DRV5013_15 Datasheet, PDF (9/27 Pages) Texas Instruments – DRV5013 Digital-Latch Hall Effect Sensor

www.ti.com
8 Detailed Description
DRV5013
SLIS150C – MARCH 2014 – REVISED SEPTEMBER 2014
8.1 Overview
The DRV5013 device is a chopper-stabilized Hall sensor with a digital latched output for magnetic sensing
applications. The DRV5013 device can be powered with a supply voltage between 2.5 and 38 V, and
continuously survives continuous –22-V reverse-battery conditions. The DRV5013 device does not operate when
–22 to 2.4 V is applied to the V_CC terminal (with respect to the GND terminal). In addition, the device can
withstand voltages up to 40 V for transient durations.
The field polarity is defined as follows: a south pole near the marked side of the package is a positive magnetic
field. A north pole near the marked side of the package is a negative magnetic field.
The output state is dependent on the magnetic field perpendicular to the package. A south pole near the marked
side of the package causes the output to pull low (operate point, B_OP), and a north pole near the marked side of
the package causes the output to release (release point, B_RP). Hysteresis is included in between the operate
point and the release point therefore magnetic-field noise does not accidentally trip the output.
An external pullup resistor is required on the OUT terminal. The OUT terminal can be pulled up to V_CC, or to a
different voltage supply. This allows for easier interfacing with controller circuits.
8.2 Functional Block Diagram
2.5 to 38 V
Regulated Supply
Bias
Temperature
Compensation
V_CC
Hall Element
+
±
Reference
C1
OCP
Gate
Drive
OUT
R1
C2
(Optional)
GND
Copyright © 2014, Texas Instruments Incorporated
Product Folder Links: DRV5013
Submit Documentation Feedback
9