DRV5013_15 Datasheet, PDF (17/27 Pages) Texas Instruments – DRV5013 Digital-Latch Hall Effect Sensor

www.ti.com
DRV5013
SLIS150C – MARCH 2014 – REVISED SEPTEMBER 2014
9.2.2.1 Configuration Example
In a 3.3-V system, 3.2 V ≤ V_ref ≤ 3.4 V. Use Equation 3 to calculate the allowable range for R1.
V_ref max _{@ R1 @} V_ref min
30 mA
100 µA
(3)
For this design example, use Equation 4 to calculate the allowable range of R1.
3.4 V _{@ R1 @} 3.2 V
30 mA
100 µA
(4)
Therefore:
113 Ω ≤ R1 ≤ 32 kΩ
(5)
After finding the allowable range of R1 (Equation 5), select a value between 500 Ω and 32 kΩ for R1.
Assuming a system bandwidth of 10 kHz, use Equation 6 to calculate the value of C2.
u
¦_BW
+]

2S
1
u R1 u
C2
(6)
For this design example, use Equation 7 to calculate the value of C2.
2 u 10 kHz 
1
2S u R1 u C2
(7)
An R1 value of 10 kΩ and a C2 value less than 820 pF satisfy the requirement for a 10-kHz system bandwidth.
A selection of R1 = 10 kΩ and C2 = 680 pF would cause a low-pass filter with a corner frequency of 23.4 kHz.
Copyright © 2014, Texas Instruments Incorporated
Product Folder Links: DRV5013
Submit Documentation Feedback
17