CC2420 Datasheet, PDF (72/92 Pages) List of Unclassifed Manufacturers – 2.4 GHz IEEE 802.15.4 / ZigBee-ready RF Transceiver

CC2420
IOCFG0 (0x1C) – I/O Configuration Register 0
Bit
15:12
11
Field Name
-
BCN_ACCEPT
10
FIFO_POLARITY
9
FIFOP_POLARITY
8
SFD_POLARITY
7
CCA_POLARITY
6:0
FIFOP_THR[6:0]
Reset
0
0
0
0
0
0
64
R/W
W0
R/W
R/W
R/W
R/W
R/W
R/W
Description
Reserved, write as 0
Accept all beacon frames when address recognition is enabled.
This bit should be set when the PAN identifier programmed into
CC2420 RAM is equal to 0xFFFF and cleared otherwise. This bit
is don't care when MDMCTRL0.ADR_DECODE = 0.
0 : Only accept beacons with a source PAN identifier which
matches the PAN identifier programmed into CC2420 RAM
1 : Accept all beacons regardless of the source PAN identifier
Polarity of the output signal FIFO.
0 : Polarity is active high
1 : Polarity is active low
Polarity of the output signal FIFOP.
0 : Polarity is active high
1 : Polarity is active low
Polarity of the SFD pin.
0 : Polarity is active high
1 : Polarity is active low
Polarity of the CCA pin.
0 : Polarity is active high
1 : Polarity is active low
FIFOP_THR sets the threshold in number of bytes in the
RXFIFO for FIFOP to go active.
IOCFG1 (0x1D) – I/O Configuration Register 1
Bit
15:13
12:10
Field Name
-
HSSD_SRC[2:0]
9:5
SFDMUX[4:0]
4:0
CCAMUX[4:0]
Reset
0
0
0
0
R/W
W0
R/W
R/W
R/W
Description
Reserved, write as 0
The HSSD module is used as follows:
0: Off.
1: Output AGC status (gain setting / peak detector status /
accumulator value)
2: Output ADC I and Q values.
3: Output I/Q after digital down mix and channel filtering.
4: Reserved
5: Reserved
6: Input ADC I and Q values
7: Input DAC I and Q values.
The HSSD module requires that the FS is up and running as it
uses CLK_PRE (~150 MHZ) to produce its ~37.5 MHz data clock
and serialize its output words.
Multiplexer setting for the SFD pin.
Multiplexer setting for the CCA pin.
MANFIDL (0x1E) - Manufacturer ID, Lower 16 Bit
Bit
15:12
11:0
Field Name
PARTNUM[3:0]
MANFID[11:0]
Reset R/W
2
R
0x33D R
Description
The device part number. CC2420 has part number 0x002.
Gives the JEDEC manufacturer ID. The actual manufacturer ID
can be found in MANIFID[7:1], the number of continuation bytes
in MANFID[11:8] and MANFID[0]=1.
Chipcon's JEDEC manufacturer ID is 0x7F 0x7F 0x7F 0x9E
(0x1E preceded by three continuation bytes.)
SWRS041B
Page 72 of 89