CC430F613X_12 Datasheet, PDF (68/121 Pages) Texas Instruments – MSP430™ SoC with RF Core

CC430F613x
CC430F612x
CC430F513x
ECCN 5E002 TSPA - Technology / Software Publicly Available
SLAS554F – MAY 2009 – REVISED DECEMBER 2011
www.ti.com
REF, External Reference
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)⁽¹⁾
V_eREF+
V_REF–/V_eREF–
(V_eREF+ –
V_REF–/V_eREF–)
I_VeREF+
I_{VREF–/VeREF–}
PARAMETER
Positive external reference voltage input
Negative external reference voltage input
Differential external reference voltage
input
Static input current
TEST CONDITIONS
V_eREF+ > V_REF–/V_eREF– ⁽²⁾
V_eREF+ > V_REF–/V_eREF– ⁽³⁾
V_eREF+ > V_REF–/V_eREF– ⁽⁴⁾
1.4 V ≤ V_eREF+ ≤ V_AVCC ,
V_eREF– = 0 V
f_ADC12CLK = 5
MHz,ADC12SHTx = 1h,
Conversion rate 200ksps
1.4 V ≤ V_eREF+ ≤ V_AVCC ,
V_eREF– = 0 V
f_ADC12CLK = 5
MHz,ADC12SHTx = 8h,
Conversion rate 20ksps
V_CC
MIN TYP
1.4
0
1.4
2.2 V/3 V
±8.5
2.2 V/3 V
C_VREF+/-
Capacitance at V_REF+/- terminal, external
reference ⁽⁵⁾
10
MAX
AV_CC
1.2
UNIT
V
V
AV_CC V
±26 µA
±1 µA
µF
(1) The external reference is used during ADC conversion to charge and discharge the capacitance array. The input capacitance, C_i, is also
the dynamic load for an external reference during conversion. The dynamic impedance of the reference supply should follow the
recommendations on analog-source impedance to allow the charge to settle for 12-bit accuracy.
(2) The accuracy limits the minimum positive external reference voltage. Lower reference voltage levels may be applied with reduced
accuracy requirements.
(3) The accuracy limits the maximum negative external reference voltage. Higher reference voltage levels may be applied with reduced
accuracy requirements.
(4) The accuracy limits minimum external differential reference voltage. Lower differential reference voltage levels may be applied with
reduced accuracy requirements.
(5) Two decoupling capacitors, 10 µF and 100 nF, should be connected to VREF to decouple the dynamic current required for an external
reference source if it is used for the ADC12_A. See also the CC430 Family User's Guide (SLAU259).
68
Submit Documentation Feedback
Copyright © 2009–2011, Texas Instruments Incorporated