English
Language : 

TLK1201IRCPRG4 Datasheet, PDF (6/22 Pages) Texas Instruments – ETHERNET TRANSCEIVERS
TLK1201RCP, TLK1201IRCP
ETHERNET TRANSCEIVERS
SLLS506E − AUGUST 2001 − REVISED MAY 2007
detailed description (continued)
transmission latency
Data transmission latency is defined as the delay from the initial 10-bit word load to the serial transmission of
bit 9. The minimum latency in TBI mode is 19 bit times. The maximum latency in TBI mode is 20 bit times. The
minimum latency in DDR mode is 29 bit times, and maximum latency in DDR mode is 30 bit times.
Measured 10-Bits
Next 10-Bit Code
TXP, TXN
td(Tx latency)
b7 b8 b9 b0 b1 b2 b3
TD(0−9)
10-Bit Code
REFCLK
Figure 1. Transmitter Latency Full Rate Mode
data reception
The receiver portion deserializes the differential serial data. The serial data is retimed based on an interpolated
clock generated from the reference clock. The serial data is then aligned to the 10-bit word boundaries and
presented to the protocol controller along with receive byte clocks (RBC0, RBC1).
receiver clock select mode
There are two modes of operation for the parallel bus. 1)The 10-bit (TBI) mode and 2) 5-bit (DDR) mode. When
in TBI mode, there are two user-selectable clock modes that are controlled by the RBCMODE terminal. 1)
Full-rate clock on RBC0 and 2) Half-rate clocks on RBC0 and RBC1. When in the DDR mode, only a full-rate
clock is available on RBC0; see Table 1.
Table 1. Mode Selection
MODESEL
0
0
1
1
RBCMODE
0
1
0
1
MODE
TBI half-rate
TBI full-rate
DDR
DDR
FREQUENCY
TLK1201
TLK1201I
30−65 MHz
30−65 MHz
60−130 MHz
60−130 MHz
60−130 MHz
60−130 MHz
60−130 MHz
60−130 MHz
In the half-rate mode, two receive byte clocks (RBC0 and RBC1) are 180 degrees out of phase and operate
at one-half the data rate. The clocks are generated by dividing down the recovered clock. The received data
is output with respect to the two receive byte clocks (RBC0, RBC1) allowing a protocol device to clock the
parallel bytes using the RBC0 and RBC1 rising edges. The outputs to the protocol device, byte 0 of the received
data is valid on the rising edge of RBC1. See the timing diagram shown in Figure 2.
6
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265