CC2500 Datasheet, PDF (6/76 Pages) Texas Instruments – Single Chip Low Cost Low Power RF Transceiver

CC2500
1 Absolute Maximum Ratings
Under no circumstances must the absolute maximum ratings given in Table 1 be violated. Stress
exceeding one or more of the limiting values may cause permanent damage to the device.
Caution! ESD sensitive device.
Precaution should be used when handling
the device in order to prevent permanent
damage.
Parameter
Supply voltage
Voltage on any digital pin
Voltage on the pins RF_P, RF_N
and DCOUPL
Voltage ramp-up rate
Input RF level
Storage temperature range
Solder reflow temperature
Min
Max
Units Condition
–0.3
3.6
V
All supply pins must have the same voltage
–0.3
VDD+0.3
V
max 3.6
–0.3
2.0
V
120
kV/µs
+10
dBm
–50
150
°C
260
°C T = 10 s
Table 1: Absolute Maximum Ratings
2 Operating Conditions
The operating conditions for CC2500 are listed Table 2 in below.
Parameter
Operating temperature
Operating supply voltage
Min
Max
Unit Condition
–40
85
°C
1.8
3.6
V All supply pins must have the same voltage
Table 2: Operating Conditions
3 General Characteristics
Parameter
Frequency range
Data rate
Min
2400
1.2
Typ
Max
Unit
Condition/Note
2483.5
MHz
500
kbps
Modulation formats supported:
(Shaped) MSK (also known as differential offset
QPSK) up to 500 kbps
2-FSK up to 500 kbps
GFSK and OOK (up to 250 kbps)
Optional Manchester encoding (halves the data rate).
Table 3: General Characteristics
Preliminary Data Sheet (rev.1.1.) SWRS040
Page 6 of 77