|
TLC34076 Datasheet, PDF (51/68 Pages) Texas Instruments – Video Interface Palette | |||
|
◁ |
3.5.1 Timing Requirements for TLC34076C Over Recommended Ranges of Supply
Voltages and Operating Temperature (see Note 5) (Continued)
-135
MIN MAX
-170
UNIT
MIN MAX
DOTCLK frequency
135
170 MHz
CLK0 frequency for VGA pass-through mode
85
85 MHz
tcyc Clock cycle time, CLK0-CLK3 (see Figure 3â2)
TTL
7.4
ECL 7.4
7.4
ns
5.8
tsu1
Setup time, RS0 â RS3 valid before RD or WRâ
(see Figure 3â1)
10
10
ns
th1
Hold time, RS0 â RS3 valid after RD or WR low (see Figure
3â1)
10
10
ns
tsu2 Setup time, D0 â D7 valid before WRâ (see Figure 3â1)
35
th2 Hold time, D0 â D7 valid after WR high (see Figure 3â1)
0
tsu3
Setup time, VGA0 â VGA7, HSYNC, VSYNC, and VGABLANK
valid before CLK0â (see Figure 3â2)
2
35
ns
0
ns
2
ns
th3
Hold time, VGA0 â VGA7, HSYNC, VSYNC, and VGABLANK
valid after CLK0 high (see Figure 3â2)
2
2
ns
tsu4 Setup time, P0 â P31 valid before SCLKâ (see Figure 3â2)
0
th4 Hold time, P0 â P31 valid after SCLK high (see Figure 3â2)
5
tsu5
Setup time, HSYNC, VSYNC, and BLANK valid before VCLK
low (see Figure 3â2)
5
0
ns
5
ns
5
ns
th5
Hold time, HSYNC, VSYNC, and BLANK valid after VCLK low
(see Figure 3â2)
2
2
ns
tw1 Pulse duration, RD or WR low (see Figure 3â1)
tw2 Pulse duration, RD or WR high (see Figure 3â1)
tw3 Pulse duration, CLK0 âCLK3 high (see Figure 3â2)
tw4 Pulse duration, CLK0 âCLK3 low (see Figure 3â2)
50
30
TTL
3
ECL
3
TTL
3
ECL
3
50
ns
30
ns
3
ns
2.5
3
ns
2.5
tw5
Pulse duration, SFLAG/NFLAG high (see Note 6 and
Figure 3â3)
30
30
ns
NOTES: 5. TTL input signals are 0 to 3 V with less than 3 ns rise/fall time between the 10% and 90% levels, unless
otherwise specified. ECL input signals are VDD â1.8 V to VDD â 0.8 V with less than 2 ns rise/fall time
between the 20% and 80% levels. For input and output signals, timing reference points are at the 10% and
90% signal levels. Analog output loads are less than 10 pF. D0 â D7 output loads are less than 50 pF. All
other output loads are less than 50 pF, unless otherwise specified.
6. This parameter applies when the split shift-register transfer (SSRT) function is enabled (see subsection
2.9.1 for details).
3â7
|
▷ |