TL16PNP550A Datasheet, PDF (32/40 Pages) Texas Instruments – ASYNCHRONOUS COMMUNICATIONS ELEMENT WITH PLUG-AND-PLAY (PnP) AND AUTOFLOW CONTROL

TL16PNP550A
ASYNCHRONOUS COMMUNICATIONS ELEMENT
WITH PLUG-AND-PLAY (PnP) AND AUTOFLOW CONTROL
SLLS190B – MARCH 1995 – REVISED MARCH 1996
PRINCIPLES OF OPERATION
interrupt identification register (IIR) (continued)
Table 15. Interrupt Control Functions
INTERRUPT
IDENTIFICATION
REGISTER
BIT 3 BIT 2 BIT 1 BIT 0
0
0
0
1
0
1
1
0
0
1
0
0
1
1
0
0
0
0
1
0
0
0
0
0
PRIORITY
LEVEL
INTERRUPT TYPE
None
1
None
Receiver line status
2
Received data available
2
Character time-out
indication
3
Transmitter holding
register empty
4
Modem status
INTERRUPT SOURCE
INTERRUPT RESET
METHOD
None
None
Overrun error, parity error,
framing error or break interrupt
Reading the line status register
Receiver data available in the
TL16C450 mode or trigger level
reached in the FIFO mode
Reading the receiver buffer
register
No characters have been
removed from or input to the
receiver FIFO during the last
four character times, and there
is at least one character in it
during this time
Reading the receiver buffer
register
Transmitter holding register
empty
Reading the interrupt
identification register (if source
of interrupt) or writing into the
transmitter holding register
Clear to send, data set ready,
ring indicator, or data carrier
detect
Reading the modem status
register
line control register (LCR)
The system programmer controls the format of the asynchronous data communication exchange through the
LCR. In addition, the programmer is able to retrieve, inspect, and modify the contents of the LCR; this eliminates
the need for separate storage of the line characteristics in system memory. The contents of this register are
summarized in Table 13 and described in the following bulleted list.
D Bits 0 and 1: These two bits specify the number of bits in each transmitted or received serial character.
These bits are encoded as shown in Table 16.
Table 16. Serial Character Word Length
BIT 1 BIT 0 WORD LENGTH
0
0
5 bits
0
1
6 bits
1
0
1
1
7 bits
8 bits
D Bit 2: This bit specifies either one, one and one-half, or two stop bits in each transmitted character. When
bit 2 is cleared, one stop bit is generated in the data. When bit 2 is set, the number of stop bits generated
is dependent on the word length selected with bits 0 and 1. The receiver clocks only the first stop bit,
regardless of the number of stop bits selected. The number of stop bits generated, in relation to word length
and bit 2, is shown in Table 17.
32
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265