MSP430F2618-EP Datasheet, PDF (1/92 Pages) Texas Instruments – MIXED SIGNAL MICROCONTROLLER

MSP430F2618- EP
MIXED SIGNAL MICROCONTROLLER
SLAS632 -- DECEMBER 2008
FEATURES
D Low Supply Voltage Range, 1.8 V to 3.6 V
D Ultra-Low Power Consumption:
-- Active Mode: 365 A at 1 MHz, 2.2 V
-- Standby Mode (VLO): 0.5 A
-- Off Mode (RAM Retention): 0.1 A
D Wake-Up From Standby Mode in Less
Than 1 s
D 16-Bit RISC Architecture,
62.5-ns Instruction Cycle Time
D Three-Channel Internal DMA
D 12-Bit Analog-to-Digital (A/D) Converter
With Internal Reference, Sample-and-Hold,
and Autoscan Feature
D Dual 12-Bit Digital-to-Analog (D/A)
Converters With Synchronization
D 16-Bit Timer_A With Three
Capture/Compare Registers
D 16-Bit Timer_B With Seven
Capture/Compare-With-Shadow Registers
D On-Chip Comparator
D Four Universal Serial Communication
Interfaces (USCIs)
-- USCI_A0 and USCI_A1
-- Enhanced UART Supporting
Auto-Baudrate Detection
-- IrDA Encoder and Decoder
-- Synchronous SPI
-- USCI_B0 and USCI_B1
-- I²Ct
-- Synchronous SPI
D Supply Voltage Supervisor/Monitor With
Programmable Level Detection
D Brownout Detector
D Bootstrap Loader
D Serial Onboard Programming,
No External Programming Voltage Needed
Programmable Code Protection by Security
Fuse
D 116KB+256B Flash Memory, 8KB RAM
D Available in 113-Pin Ball Grid Array (BGA)
D For Complete Module Descriptions, See the
MSP430x2xx Family User’s Guide,
Literature Number SLAU144
SUPPORTS DEFENSE, AEROSPACE, AND
MEDICAL APPLICATIONS
D Controlled Baseline
D One Assembly/Test Site
D One Fabrication Site
D Extended Product Life Cycle
D Extended Product--Change Notification
D Product Traceability
D SnPb Solder Ball Alloy for Increased
Reliability
description
The Texas Instruments MSP430 family of ultralow-power microcontrollers consists of several devices featuring
different sets of peripherals targeted for various applications. The architecture, combined with five low-power
modes is optimized to achieve extended battery life in portable measurement applications. The device features
a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code
efficiency. The calibrated digitally controlled oscillator (DCO) allows wake-up from low-power modes to active
mode in less than 1 s.
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage. ESD damage can range
from subtle performance degradation to complete device failure. Precision integrated circuits may be more susceptible to damage
because very small parametric changes could cause the device not to meet its published specifications. These devices have limited
built-in ESD protection.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
I²C is a registered trademark of Philips Incorporated.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Copyright  2008, Texas Instruments Incorporated
 POST OFFICE BOX 655303 DALLAS, TEXAS 75265
1