SM39R08A5 Datasheet, PDF (23/58 Pages) SyncMOS Technologies,Inc – Additional Baud Rate Generator

SM39R08A5
8-Bit Micro-controller
with 8KB Flash
& 256B RAM embedded
5. GPIO
5.1. SFR Setting Method
The SM39R08A5 has one I/O ports: Port 3. These are quasi-bidirectional (standard 8051 port outputs), push-pull, open
drain, and input-only. Two configuration registers for each port select the output type for each port pin. All I/O port pins on
the SM39R08A5 may be configured by software to one of four types on a pin-by-pin basis, shown as below:
Mnemonic
P3M0
P3M1
Description
Port 3 output mode 0
Port 3 output mode 1
Direct Bit 7 Bit 6 Bit 5 Bit 4 Bit 3
I/O port function register
DAh
P3M0[7:0]
DBh
P3M1[7:0]
Bit 2
Bit 1
Bit 0
RESET
00H
00H
PxM1.y
0
0
1
1
PxM0.y
0
1
0
1
Port output mode
Quasi-bidirectional (standard 8051 port outputs) (pull-up)
Push-pull
Input only (high-impedance)
Open drain
The RESET Pin can be configured as I/O port P3.6, when the user uses on-chip hardware RESET mechanism.
For general-purpose applications, every pin can be assigned to either high or low independently as given below:
Mnemonic Description Direct Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 RESET
Ports
Port 3
Port 3
B0h P3.7 P3.6 P3.5 P3.4 P3.3 P3.2 P3.1 P3.0 FFh
Mnemonic: P3
7
6
P3.7 P3.6
5
P3.5
4
P3.4
3
P3.3
2
P3.2
1
P3.1
Address: B0h
0 Reset
P3.0 FFh
P3.7~ 0: Port3 [7] ~ Port3 [0]
5.2. Software of Writer Setting Method
Please Setting the “IO Output Mode" item in the "Configuration" window, it can change the I/O mode of P3 to the
“Quasi-bidirectional (standard 8051 port outputs) (pull-up)” or Input only (high-impedance) mode, When MCU after reset
and initial. It is supported the version E of MCU after.
Specifications subject to change without notice contact your sales representatives for the most recent information.
ISSFD-M067
Ver E SM39R08A5 06/30/2015
- 23 -