LSM330DLC Datasheet, PDF (49/66 Pages) STMicroelectronics – iNEMO inertial module: 3D accelerometer and 3D gyroscope

LSM330DLC
Register descriptions
Table 46. INT1_SRC_A description (continued)
Y high. Default value: 0
YH
(0: no interrupt, 1: Y High event has occurred)
Y low. Default value: 0
YL
(0: no interrupt, 1: Y Low event has occurred)
X high. Default value: 0
XH
(0: no interrupt, 1: X High event has occurred)
X low. Default value: 0
XL
(0: no interrupt, 1: X Low event has occurred)
Interrupt 1 source register. Read only register.
Reading at this address clears INT1_SRC_A IA bit (and the interrupt signal on INT 1 pin)
and allows the refreshing of the data in the INT1_SRC_A register if the latched option was
chosen.
8.16
INT1_THS_A (32h)
Table 47. INT1_THS_A register
0⁽¹⁾
THS6
THS5
THS4
1. This bit has to be set ‘0’ for correct operation.
THS3
THS2
THS1
THS0
Table 48. INT1_THS_A description
THS6 - THS0 Interrupt 1 threshold. Default value: 000 0000
8.17 INT1_DURATION_A (33h)
Table 49. INT1_DURATION_Aregister
0⁽¹⁾
D6
D5
D4
D3
D2
D1
D0
1. This bit must be set ‘0’ for correct operation.
Table 50. INT1_DURATION_A description
D6 - D0
Duration value. Default value: 000 0000
D6 - D0 bits set the minimum duration of the Interrupt 1 event to be recognized. Duration
steps and maximum values depend on the ODR chosen.
Doc ID 022162 Rev 2
49/66