SERCON410B Datasheet, PDF (33/34 Pages) STMicroelectronics – SERCOS INTERFACE CONTROLLER

5 PACKAGE MECHANICAL DATA
Figure 15. SERCON410B 100 Pin Plastic Quad Flat Pack Package
SERCON410B
Dim.
mm
inches
Min Typ Max Min Typ Max
A
3.40
0.134
A2 2.55 2.80 3.05 0.100 0.110 0.120
D 23.65 23.90 24.15 0.931 0.941 0.951
D1 19.90 20.00 20.10 0.783 0.787 0.791
D3
18.85
0.742
E 17.65 17.90 18.15 0.695 0.705 0.715
E1 13.90 14.00 14.10 0.547 0.551 0.555
E3
12.35
0.486
e
0.65
0.026
Number of Pins
ND
30
NE
20
N
100
6 ADDITIONAL SUPPORT AND TOOLS
6.1 SERCOS INTERFACE SPECIFICATION
The SERCOS interface specification is available
at:
Fördergemeinschaft SERCOS interface e.V.
Herseler Str. 31
D-50389 Wesseling
Tel. xx49-2236-1517
Fax. xx49-2236-1542
6.2 SOFTWARE AND BOARDS FOR THE
SERCON410B
Driver software SERCDRV
Master and slave routines for the SERCON410B
Written in ANSI-C
Independent from operating system and processor
Contains:
- ^{initialization}
- ^{start-up of SERCOS interface (phases 0 - 4)}
- ^{service channel transmission}
Easy portable to many microprocessors and hard-
ware platforms
PC-AT board SERCEB
16-bit ISA bus
Receiver and transmitter for fibre optics (SERCOS
interface standard)
SERCON410B and additional timerchip 82C54
Additional RS-485-signals for serial connection
and synchronization
Wire wrap area for extension
Add-on board SERCINT
Multiplexed 16-bit address/data-bus
Receiver and transmitter for fibre optics (SERCOS
interface standard)
SERCON410B
Additional RS-485-signals for serial connection
These software and boards are available at:
IAM GmbH
Vertrieb Systemtechnik
Richard-Wagner-Str. 1
D-38106 Braunschweig
Tel. xx49-531-3802-0
Fax. xx49-531-3802-110
29/30
®