COM20022I Datasheet, PDF (43/83 Pages) SMSC Corporation – 10 MBPS ARCNET CONTROLLER WITH 2KX8 ON BOARD RAM

10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM
Datasheet
BIT
BIT NAME
7 Reset
6 Command
Chaining Enable
5 Transmit Enable
4,3 Extended
Timeout 1,2
2 Backplane
1,0 Sub Address 1,0
Table 6.9 - Configuration Register
SYMBOL
RESET
CCHEN
TXEN
ET1, ET2
DESCRIPTION
A software reset of the COM20022I is executed by writing a logic
"1" to this bit. A software reset does not reset the microcontroller
interface mode, nor does it affect the Configuration Register. The
only registers that the software reset affect are the Status
Register, the Next ID Register, and the Diagnostic Status
Register. This bit must be brought back to logic "0" to release the
reset.
This bit, if high, enables the Command Chaining operation of the
device. Please refer to the Command Chaining section for further
details. A low level on this bit ensures software compatibility with
previous SMSC ARCNET devices.
When low, this bit disables transmissions by keeping nPULSE1,
nPULSE2 if in non-Backplane Mode, and nTXEN pin inactive.
When high, it enables the above signals to be activated during
transmissions. This bit defaults low upon reset. This bit is
typically enabled once the Node ID is determined, and never
disabled during normal operation. Please refer to the Improved
Diagnostics section for details on evaluating network activity.
These bits allow the network to operate over longer distances
than the default maximum 1 mile by controlling the Response,
Idle, and Reconfiguration Times. All nodes should be configured
with the same timeout values for proper network operation. For
the COM20022I with a 20 MHz crystal oscillator, the bit
combinations follow:
Reconfig
Response Idle Time
Time
ET2
ET1
Time (µS)
(µS)
(mS)
0
0
298.4
328
420
0
1
149.2
164
420
1
0
74.7
82
420
1
1
18.7
20.5
210
Note: These values are for 10Mbps and RCNTMR[1,0]=00.
Reconfiguration time is changed by the RCNTMR1 and
RCNTMR0 bits.
BACK-
PLANE
A logic "1" on this bit puts the device into Backplane Mode
signaling which is used for Open Drain and Differential Driver
interfaces.
SUBAD 1,0
These bits determine which register at address 07 may be
accessed. The combinations are as follows:
SUBAD1
SUBAD0
Register
0
0
Tentative ID
0
1
Node ID
1
0
Setup 1
1
1
Next ID
See also the Sub Address Register.
SMSC COM20022I
Page 43
DATASHEET
Rev. 08-18-03