LAN9215_12 Datasheet, PDF (40/144 Pages) SMSC Corporation – 16-bit Non-PCI 10/100 Ethernet Controller with HP Auto-MDIX Support

16-bit Non-PCI 10/100 Ethernet Controller with HP Auto-MDIX Support
Datasheet
Table 3.8, "Required EECLK Cycles", shown below, shows the number of EECLK cycles required for
each EEPROM operation.
Table 3.8 Required EECLK Cycles
OPERATION
ERASE
ERAL
EWDS
EWEN
READ
WRITE
WRAL
REQUIRED EECLK CYCLES
10
10
10
10
18
18
18
3.8.2.2
3.8.2.3
3.8.2.4
MAC Address Reload
The MAC address can be reloaded from the EEPROM via a host command to the E2P_CMD register.
If a value of 0xA5h is not found in the first address of the EEPROM, the EEPROM is assumed to be
un-programmed and MAC Address Reload operation will fail. The “MAC Address Loaded” bit indicates
a successful load of the MAC address. The EPC_LOAD bit is set after a successful reload of the MAC
address.
EEPROM Command and Data Registers
Refer to Section 5.3.23, "E2P_CMD – EEPROM Command Register," on page 98 and Section 5.3.24,
"E2P_DATA – EEPROM Data Register," on page 100 for a detailed description of these registers.
Supported EEPROM operations are described in these sections.
EEPROM Timing
Refer to Section 6.9, "EEPROM Timing," on page 132 for detailed EEPROM timing specifications.
3.9
Power Management
The LAN9215 supports power-down modes to allow applications to minimize power consumption. The
following sections describe these modes.
3.9.1 System Description
Power is reduced to various modules by disabling the clocks as outlined in Table 3.9, “Power
Management States,” on page 42. All configuration data is saved when in either of the two low power
states. Register contents are not affected unless specifically indicated in the register description.
3.9.2 Functional Description
There is one normal operating power state, D0 and there are two power saving states: D1, and D2.
Upon entry into either of the two power saving states, only the PMT_CTRL register is accessible for
read operations. In either of the power saving states the READY bit in the PMT_CTRL register will be
cleared. Reads of any other addresses are forbidden until the READY bit is set. All writes, with the
exception of the wakeup write to BYTE_TEST, are also forbidden until the READY bit is set. Only when
in the D0 (Normal) state, when the READY bit is set, can the rest of the device be accessed.
Revision 2.9 (03-01-12)
40
DATASHEET
SMSC LAN9215