English
Language : 

LAN9215_12 Datasheet, PDF (18/144 Pages) SMSC Corporation – 16-bit Non-PCI 10/100 Ethernet Controller with HP Auto-MDIX Support
16-bit Non-PCI 10/100 Ethernet Controller with HP Auto-MDIX Support
Datasheet
Note: The pin names for the twisted pair pins shown above apply to a normal connection. If HP Auto-
MDIX is enabled and a reverse connection is detected, or a reverse connection is manually
selected, the input pins become outputs, and vice-versa, as indicated in the descriptions.
Table 2.4 Serial EEPROM Interface Signals
NAME
EEPROM Data,
GPO3, TX_EN,
TX_CLK
EEPROM Chip
Select
EEPROM Clock,
GPO4 RX_DV,
RX_CLK
SYMBOL
BUFFER
TYPE
EEDIO/GPO3/
I/O8
TX_EN/TX_CLK
EECS
O8
EECLK/GPO4/
O8
RX_DV/RX_CLK
NUM
PINS
1
1
1
DESCRIPTION
EEPROM Data: This bi-directional pin can be
connected to a serial EEPROM DIO. This is
optional.
General Purpose Output 3: This pin can also
function as a general purpose output, or it can
be configured to monitor the TX_EN or
TX_CLK signals on the internal MII port. When
configured as a GPO signal, or as a
TX_EN/TX_CLK monitor, the EECS pin is
deasserted so as to never unintentionally
access the serial EEPROM. This signal cannot
function as a general-purpose input.
Serial EEPROM chip select.
EEPROM Clock: Serial EEPROM Clock pin.
General Purpose Output 4: This pin can also
function as a general-purpose output, or it can
be configured to monitor the RX_DV or
RX_CLK signals on the internal MII port. When
configured as a GPO signal, or as an
RX_DV/RX_CLK monitor, the EECS pin is
deasserted so as to never unintentionally
access the serial EEPROM. This signal cannot
function as a general-purpose input.
Note:
When the EEPROM interface is not
used, the EECLK pin must be left
unconnected.
Revision 2.9 (03-01-12)
18
DATASHEET
SMSC LAN9215