LAN91C100FD_0601 Datasheet, PDF (26/78 Pages) SMSC Corporation – FEAST Fast Ethernet Controller with Full Duplex Capability

FEAST Fast Ethernet Controller with Full Duplex Capability
PRMS - Promiscuous mode. When set receives all frames. Does not receive its own transmission unless
it is in Full Duplex!
RX_ABORT - This bit is set if a receive frame was aborted due to length longer than 2K bytes. The frame
will not be received. The bit is cleared by RESET or by the CPU writing it low.
Reserved - Must be 0.
BANK 0
OFFSET
6
NAME
COUNTER REGISTER
TYPE
READ ONLY
SYMBOL
ECR
Counts four parameters for MAC statistics. When any counter reaches 15 an interrupt is issued. All
counters are cleared when reading the register and do not wrap around beyond 15.
HIGH
BYTE
LOW
BYTE
NUMBER OF EXC. DEFFERED TX
0
0
0
0
MULTIPLE COLLISION COUNT
0
0
0
0
NUMBER OF DEFFERED TX
0
0
0
0
SINGLE COLLISION COUNT
0
0
0
0
Each four bit counter is incremented every time the corresponding event, as defined in the EPH STATUS
REGISTER bit description, occurs. Note that the counters can only increment once per enqueued transmit
packet, never faster, limiting the rate of interrupts that can be generated by the counters. For example if a
packet is successfully transmitted after one collision the SINGLE COLLISION COUNT field is incremented
by one. If a packet experiences between 2 to 16 collisions, the MULTIPLE COLLISION COUNT field is
incremented by one. If a packet experiences deferral the NUMBER OF DEFERRED TX field is
incremented by one, even if the packet experienced multiple deferrals during its collision retries.
The COUNTER REGISTER facilitates maintaining statistics in the AUTO RELEASE mode where no
transmit interrupts are generated on successful transmissions.
Reading the register in the transmit service routine will be enough to maintain statistics.
BANK 0
OFFSET
8
NAME
MEMORY INFORMATION
REGISTER
TYPE
READ ONLY
SYMBOL
MIR
HIGH
BYTE
FREE MEMORY AVAILABLE (IN BYTES * 256 * M)
1
1
1
1
1
1
1
1
LOW
BYTE
MEMORY SIZE (IN BYTES *256 * M)
1
1
1
1
1
1
1
1
FREE MEMORY AVAILABLE - This register can be read at any time to determine the amount of free
memory. The register defaults to the MEMORY SIZE upon reset or upon the RESET MMU command.
MEMORY SIZE - This register can be read to determine the total memory size.
All memory related information is represented in 256 * M byte units, where the multiplier M is determined
by the MCR upper byte.
Rev. 01-20-06
Page 26
DATASHEET
SMSC DS – LAN91C100FD Rev. D