EFM8UB2 Datasheet, PDF (38/50 Pages) Silicon Laboratories – The EFM8UB2 highlighted features are listed below

EFM8UB2 Data Sheet
QFP48 Package Specifications
Dimension
Min
Max
Note:
1. All dimensions shown are in millimeters (mm) unless otherwise noted.
2. This Land Pattern Design is based on the IPC-7351 guidelines.
3. All metal pads are to be non-solder mask defined (NSMD). Clearance between the solder mask and the metal pad is to be 60 µm
minimum, all the way around the pad.
4. A stainless steel, laser-cut and electro-polished stencil with trapezoidal walls should be used to assure good solder paste release.
5. The stencil thickness should be 0.125 mm (5 mils).
6. The ratio of stencil aperture to land pad size should be 1:1 for all perimeter pads.
7. A No-Clean, Type-3 solder paste is recommended.
8. The recommended card reflow profile is per the JEDEC/IPC J-STD-020C specification for Small Body Components.
7.3 QFP48 Package Marking
EFM8
PPPPPPPP
TTTTTT
YYWW #
Figure 7.3. QFP48 Package Marking
The package marking consists of:
• PPPPPPPP – The part number designation.
• TTTTTT – A trace or manufacturing code.
• YY – The last 2 digits of the assembly year.
• WW – The 2-digit workweek when the device was assembled.
• # – The device revision (A, B, etc.).
silabs.com | Smart. Connected. Energy-friendly.
Rev. 1.2 | 37