UPIO-M3U1XX Datasheet, PDF (3/28 Pages) Silicon Laboratories – The Unified Development Platform (UDP) provides a development

UPIO-M3U1xx
3. Hardware Setup
Refer to Figure 2 for a diagram of the hardware configuration
1. Connect an MCU card to the UDP motherboard slot.
2. Connect the I/O card to the UDP motherboard slot.
3. (Optional) Connect a radio test card to the radio test card slot in the UDP motherboard.
4. (Optional) Connect an EZLink card to the EZLink card slot in the UDP motherboard.
5. Connect the USB Debug Adapter to the 2x5 debug connector on the MCU card with the 10-pin ribbon
cable.
6. Connect one end of the USB cable to the USB connector on the USB Debug Adapter.
7. Connect the other end of the USB cable to a USB Port on the PC.
8. Connect the ac/dc power adapter to power jack J20 on the UDP motherboard. The board can also be
powered from the J16 USB or J1 mini USB connectors.
9. Move the S3 power switch on the UDP motherboard to the ON position.
Notes:
Use the Reset button in the IDE to reset the target when connected using a USB Debug Adapter.
Remove power from the target board and the USB Debug Adapter before connecting or disconnecting the
ribbon cable from the target board. Connecting or disconnecting the cable when the devices have power
can damage the device and/or the USB Debug Adapter.
The MCU card can be used alone without the motherboard. However, the motherboard must be powered if
an MCU card is connected.
USB Debug Adapter
USB
Connector
(J16)
Power
Adapter
(J20)
Figure 2. Hardware Setup using the Unified Development Platform
Rev. 0.1
3