LC875CC8A Datasheet, PDF (4/29 Pages) Sanyo Semicon Device – ROM 128K/112K byte, RAM 4096 byte on-chip 8-bit 1-chip Microcontroller

LC875CC8A/B2A
„Standby Function
• HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.
1) Oscillation is not halted automatically.
2) Canceled by system reset or occurrence of interrupt.
• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.
1) The CF, RC, and crystal oscillators automatically stop operation.
2) There are three ways of resetting the HOLD mode.
(1) Setting the Reset pin to the lower level
(2) Setting at least one of the INT0, INT1, INT2, INT4, and INT5 pins to the specified level
(3) Having an interrupt source established at port 0
• X'tal HOLD mode: Suspends instruction execution and the operation of the peripheral circuits except the base timer.
1) The CF and RC oscillators automatically stop operation.
2) The state of crystal oscillation established when the HOLD mode is entered is retained.
3) There are four ways of resetting the X'tal HOLD mode.
(1) Setting the Reset pin to the low level.
(2) Setting at least one of the INT0, INT1, INT2, INT4, and INT5 pins to the specified level.
(3) Having an interrupt source established at port 0.
(4) Having an interrupt source established in the base timer circuit.
„Package Form
• QIP100E(14×20): “Lead-free type”
• TQFP100(14×14): “Lead-free type”
„Development Tools
• Evaluation (EVA) chip : LC87EV690
• Emulator
: EVA62S + ECB876600D + SUB875C00
+ POD100QFP or POD100SQFP Type B
: ICE-B877300 + SUB875C00 + POD100QFP or POD100SQFP Type B
• Flash version
: LC87F5CC8A
No.A0744-4/29