LC875CC8A Datasheet, PDF (25/29 Pages) Sanyo Semicon Device – ROM 128K/112K byte, RAM 4096 byte on-chip 8-bit 1-chip Microcontroller

LC875CC8A/B2A
VDD1, VSS1 Terminal Condition
It is necessary to place capacitors between VDD1 and VSS1 as described below.
• Place capacitors as close to VDD1 and VSS1 as possible.
• Place capacitors so that the length of each terminal to the each leg of the capacitor be equal (L1 = L1’, L2 = L2’).
• Place high capacitance capacitor C1 and low capacitance capacitor C2 in parallel.
• Capacitance of C2 must be more than 0.1μF.
• Use thicker pattern for VDD1 and VSS1.
L2
L1
VSS1
C1
C2
L1’
L2’
VDD1
VDD3, VSS3 Terminal Condition
It is necessary to place capacitors between VDD3 and VSS3 as described below.
• Place capacitors as close to VDD3 and VSS3 as possible.
• Place capacitors so that the length of each terminal to the each leg of the capacitor be equal (L3 = L3’).
• Capacitance of C3 must be more than 0.1μF.
• Use thicker pattern for VDD3 and VSS3.
L3
VSS3
C3
VDD3
L3’
No.A0744-25/29