English
Language : 

KFG5616Q1A-DEB5 Datasheet, PDF (92/113 Pages) Samsung semiconductor – OneNAND Specification FLASH MEMORY
OneNAND256(KFG5616x1A-xxB5)
FLASH MEMORY
5.5 AC Characteristics for Asynchronous Read
See Timing Diagrams 6.3, 6.4, 6.5 and 6.6
Parameter
Access Time from CE Low
Asynchronous Access Time from AVD Low
Asynchronous Access Time from address valid
Read Cycle Time
AVD Low Time
Address Setup to rising edge of AVD
Address Hold from rising edge of AVD
Output Enable to Output Valid
WE disable to OE enable
CE Setup to AVD falling edge
CE Disable to Output & RDY High Z1)
OE Disable to Output High Z1)
WE Disable to AVD Enable
Symbol
tCE
tAA
tACC
tRC
tAVDP
tAAVDS
tAAVDH
tOE
tOEH
tCA
tCEZ
tOEZ
tWEA
KFG5616x1A
Min
Max
-
76
-
76
-
76
76
-
12
-
7
-
7
-
-
20
0
-
0
-
-
20
-
17
15
-
NOTE:
1. If OE is disabled at the same time or before CE is disabled, the output will go to high-z by tOEZ.
If CE is disabled at the same time or before OE is disabled, the output will go to high-z by tCEZ.
If CE and OE are disabled at the same time, the output will go to high-z by tOEZ.
These parameters are not 100% tested.
Unit
Unit
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
5.6
AC Characteristics for Warm Reset (RP), Hot Reset
and NAND Flash Core Reset
See Timing Diagrams 6.12, 6.13 and 6.14
Parameter
Symbol
Min
Max
Unit
RP & Reset Command Latch to BootRAM Access
tReady1
(BufferRAM)
-
5
µs
RP & Reset Command Latch(During Load Routines) to INT High (Note1)
tReady2
(NAND Flash Array)
-
10
µs
RP & Reset Command Latch(During Program Routines) to INT High (Note1)
tReady2
(NAND Flash Array)
-
20
µs
RP & Reset Command Latch(During Erase Routines) to INT High (Note1)
tReady2
(NAND Flash Array)
-
500
µs
RP & Reset Command Latch(NOT During Internal Routines) to INT High (Note1)
tReady2
(NAND Flash Array)
-
10
µs
RP Pulse Width (Note2)
tRP
200
-
ns
Note
1. These parameters are tested based on INT bit of interrupt register. Because the time on INT pin is related to the pull-up and pull-down resistor value.
2. The device may reset if tRP < tRP min(200ns), but this is not guaranteed.
92