R0E00008AKCE00EP52 Datasheet, PDF (7/43 Pages) Renesas Technology Corp – Microcomputer Development Environment System

E8a Emulator
3. Connecting the E8a Emulator to the User System
3. Connecting the E8a Emulator to the User System
3.1 Connector for connecting the E8a emulator and the user system
Before connecting the E8a emulator to the user system, a connector must be installed in the user system so a user system
interface cable can be connected. Table 3.1 shows the recommended connector for the E8a emulator and Figure 3.2
shows E8a connecting connector pin assignments.
When designing the user system, refer to Figure 3.2 “E8a Connecting Connector Pin Assignments” and Section 3
“Connecting the E8a Emulator to the User System”.
Before designing the user system, be sure to read the E8a Emulator User’s Manual and related device hardware manuals.
Table 3.1 Recommended Connector
Type Number
14-pin connector 2514-6002
Manufacturer
3M Limited
Specification
14-pin straight type
User system interface cable
Pin 2
Connector
User system
Pin 1
Figure 3.1 Connecting the User System Interface Cable with an E8a Connecting Connector
Notes
z Do not place any components within 3 mm area of the connector.
z When using the E8a emulator as a programmer, connect it to the user system in the same way.
z Connect E8a connecting connector pins 2, 4, 6, 10, 12 and 14 firmly to the GND on the user system board.
These pins are used as an electric GND and monitor the connection of the user system connector.
REJ10J1877-0201 Rev.2.01 Jun. 26, 2009
Page 7 of 43