R0E00008AKCE00EP52 Datasheet, PDF (32/43 Pages) Renesas Technology Corp – Microcomputer Development Environment System

E8a Emulator
6. Notes on Using the E8a Emulator
6. Notes on Using the E8a Emulator
6.1 MCU resources used by the E8a emulator
(1) Program area for the E8a emulator
Table 6.1 lists the program areas allotted for the E8a emulator. Do not change this area allocation, otherwise the E8a emulator
will not control the MCU. If settings were changed, disconnect the debugger and then reconnect it.
Table 6.1 Program Area for the E8a Emulator
Vector Area
Program Area for E8a Emulator
ROM Area
RAM Area
FFFFFFFCh - FFFFFFFFh ^{3 KB of the Program Area [*1]}
364 B [*1]
Note
[*1] When starting the debugger, the [Emulator Setting] dialog box is displayed. Specify the area which will not be used
by the user system. For details, see 5.3 [Firmware Location] tab.
(2) Pins used by the E8a emulator
The E8a emulator controls the MCUs by using the following pins depending on the usage.
- For debugging/programming (R32C/160 and R32C/161):
RESET#, CNVss, P50, P55, P44, P45, P46, and P47 pins
- For debugging/programming (R32C/111 (64-pin and 80-pin)): RESET#, CNVss, P80, P81, P64, P65, P66, and P67 pins
- For debugging/programming (other than the above):
RESET#, CNVss, P50, P55, P64, P65, P66, and P67 pins
REJ10J1877-0201 Rev.2.01 Jun. 26, 2009
Page 32 of 43