R0E00008AKCE00EP52 Datasheet, PDF (30/43 Pages) Renesas Technology Corp – Microcomputer Development Environment System

E8a emulator
5. Emulator Debugger Setting
5.3 [Firmware Location] tab
You can specify the address of the firmware location in the [Firmware Location] tab.
[Firmware Location]
Select the area in which the firmware is located.
Specify the address that will not be used by the user
system in the ROM area or RAM area.
- Program
Specify the ROM area in which the firmware is
located. Specify 3K bytes that will not be used by
the user system.
- Work RAM
Specify the RAM area in which the firmware is
located. Specify 364 bytes that will not be used
by the user system.
Figure 5.3 [Firmware Location] tab of [Emulator Setting] Dialog Box
[Debugging of program that uses WDT]
When debugging the user program using the
watchdog timer, click this check box.
- Unchecked: WDT is not used.
If the watchdog timer is enabled with this box
unchecked during debugging, the E8a emulator
will not operate normally.
- Checked: WDT is used.
The E8a emulator program refreshes the
watchdog timer during program operation.
If memory access is executed through memory
reference or modification, the watchdog timer
will be refreshed by the E8a emulator program.
Note that this timing will differ from the actual
operational timing.
REJ10J1877-0201 Rev.2.01 Jun. 26, 2009
Page 30 of 43