QB-RL78L1C Datasheet, PDF (30/42 Pages) Renesas Technology Corp – In-Circuit Emulator

QB-RL78L1C In-Circuit Emulator
CHAPTER 2 SETUP PROCEDURE
2.5 Notes on Power Supply and GND Pin Connection
For power supplies and GND pins of the target device, be sure to connect all pins to each power supply or GND.
2.6 Connecting USB Interface Cable and AC Adapter
Plug the USB interface cable supplied with the QB-RL78L1C into the USB connector of the host machine, and plug the
other side into the USB connector on the rear of the QB-RL78L1C.
Plug the AC adapter into the power supply connector on the rear of the QB-RL78L1C and plug the other side into a
receptacle.
For QB-RL78L1C connector positions, see Figure 2-8.
Figure 2-8. Connector Positions
Power supply connector
(Connect AC adapter)
USB connector
(Connect USB interface cable)
2.7 Switching Power On and Off
Be sure to switch the power on and off according to the following procedures.
- Switching power on
<1> QB-RL78L1C power on
<2> Target system power on^Note
<3> Debugger startup
- Switching power off
<1> Debugger termination
<2> Target system power off^Note
<3> QB-RL78L1C power off
Note In the procedures, <2> is unnecessary if the target system is not connected.
Caution If the wrong sequence was used for the operation, the target system or QB-RL78L1C may fail
R20UT2703EJ0200 Rev.2.00
Jan 31, 2014
Page 30 of 42