QB-RL78L1C Datasheet, PDF (22/42 Pages) Renesas Technology Corp – In-Circuit Emulator

QB-RL78L1C In-Circuit Emulator
CHAPTER 2 SETUP PROCEDURE
(2) Internal high-speed oscillation clock
This method uses the clock inside the emulator by configuring the use of the high-speed oscillation clock in the
user program.
(3) Internal low-speed oscillation clock
This method uses the clock inside the emulator by configuring the use of the low-speed oscillation clock in the
user program.
(4) Subsystem clock
The clock settings are listed below.
Table 2-3. Settings for Subsystem Clock
Type of Clock to Be Used
(a) When the clock generated within the emulator is used
(b) When the clock (a square wave) is supplied from the target system
(a) When the clock generated within the emulator is used
This method uses the clock inside the emulator by configuring the use of the subsystem clock in the user
program. For debugger settings, check the user's manual for the debugger that will be used.
(b) When the clock (a square wave) is supplied from the target system
The clock input from the target system is then used.
To input a clock from the target system, input to the clock pin (XT2) the square-wave signal with the same
voltage potential as that of the target device supply voltage (VDD). Inputting the inverted signal to XT1 is
not necessary.
The selectable frequencies are same as those of the target device.
For debugger settings, check the user's manual for the debugger that will be used. Oscillation by a
resonator in the target system is not supported.
R20UT2703EJ0200 Rev.2.00
Jan 31, 2014
Page 22 of 42