QB-RL78L1C Datasheet, PDF (11/42 Pages) Renesas Technology Corp – In-Circuit Emulator

QB-RL78L1C In-Circuit Emulator
1.3 System Specifications
CHAPTER 1 GENERAL
This section shows the QB-RL78L1C system specifications.
Table 1-2. QB-RL78L1C System Specifications
Parameter
Specification
Emulation memory capacity Internal ROM
512 KB (MAX.)
Internal RAM
61.75 KB (MAX.)
Program execution
functions
Real-time execution function
Go, Start from Here, Come Here, Restart, Return Out,
Ignore break points and Go
Non-real-time execution function Step In, Next Over, Slow motion, Go & Go
Memory manipulation
Available (initialize, copy, compare)
Register manipulation
Available (general-purpose registers, control registers, SFRs)
Disassemble function
Available
Local variable view
Local variables
Watch data view
Local variables, global variables, or else
Stack trace view
Available
Break functions
Event break
Execution: 8 points
Access: 8 points
Software break
2000 points
Pre-execution break
4 points
Fail-safe break
Non-map, write protect, SFR illegal access, stack overflow, or else
Other
Forcible break, trace full break, trace delay break, timeout break,
timer overflow break
Trace functions
Trace data types
Program address, program data, access address, access data,
status, time tag
Trace modes
Unconditional trace, section trace, qualify trace, delay trigger trace
Trace functions
Non-stop, full stop, full break, delay trigger stop, delay trigger
break
Memory capacity
128K frames
Real-time RAM monitoring function
All internal RAM spaces
Time measurement
functions
Measurement clock
Measurement objects
120 MHz
Start through end of program execution
Start event through end event
Maximum measurement time
Approx. 40 hours and 43 minutes
Minimum resolution
8ns
Number of timers for
measurement
Start through end of program execution: 1
Start event through end event: 2
Measurement results
Execution time (start through end of execution)
Maximum, minimum, average, total, pass count (between events)
Other
Timer overflow break function, timeout break function
Other functions
Command functions set in the console, mapping function, event
function, coverage function, snapshot function, DMM function,
power-off emulation function, pin mask function, flash self
programming emulation function
R20UT2703EJ0200 Rev.2.00
Jan 31, 2014
Page 11 of 42