QB-RL78L1C Datasheet, PDF (19/42 Pages) Renesas Technology Corp – In-Circuit Emulator

QB-RL78L1C In-Circuit Emulator
2.1 Software Settings
Check the user's manual for the debugger that will be used.
2.2 Clock Settings
CHAPTER 2 SETUP PROCEDURE
The QB-RL78L1C clock must be set to the clock used by the target device. For details about how to set the clock,
check the user's manual for the debugger that will be used.
QB-RL78L1C clock settings for the clock used by the target device are shown below.
Oscillation with the resonator on the target system is not supported. Therefore, the in-circuit emulator cannot
emulate the oscillation operation of the clock on the target system.
Table 2-1. List of clock settings
Clock Used
Clock Supply
(1) High-speed system clock
(X1 oscillator or External input)
(a) When the clock generated within the emulator is used
(b) When the clock (a square wave) is supplied from the
target system
(c) When the oscillator (OSC1) mounted onto the emulator
is used
(2) Internal high-speed
oscillation clock
Uses the clock internally generated from the emulator
(3) Internal low-speed
oscillation clock
Uses the clock internally generated from the emulator
(4) Subsystem clock
(XT1 oscillator or External
input)
(a) When the clock generated within the emulator is used
(b) When the clock (a square wave) is supplied from the
target system
R20UT2703EJ0200 Rev.2.00
Jan 31, 2014
Page 19 of 42