H8S2117 Datasheet, PDF (178/968 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family / H8S/2100 Series

Section 7 I/O Ports
7.2 Output Buffer Control
This section describes the output priority of each pin.
The name of each peripheral module pin is followed by “_OE”. This (for example: TIOCA4_OE)
indicates whether the output of the corresponding function is valid (1) or if another setting is
specified (0). Table 7.4 lists each port output signal's valid setting. For details on the
corresponding output signals, see the register description of each peripheral module.
7.2.1 Port 1
(1) P17 to P10
The pin function is switched as shown below according to the P1nDDR bit setting.
Module Name
I/O port
Pin Function
P1n output
P1n input
(initial setting)
Setting
I/O Port
P1nDDR
1
0
(n = 7 to 0)
7.2.2 Port 2
(1) P27 to P20
The pin function is switched as shown below according to the P2nDDR bit setting.
Module Name
I/O port
Pin Function
P2n output
P2n input
(initial setting)
Setting
I/O Port
P2nDDR
1
0
(n = 7 to 0)
Rev. 2.00 Feb. 20, 2008 Page 154 of 940
REJ09B0350-0200