BUK213-50Y Datasheet, PDF (6/16 Pages) NXP Semiconductors – Single channel high-side TOPFET

Philips Semiconductors
BUK208-50Y; BUK213-50Y
Single channel high-side TOPFET™
Table 6: Static characteristics…continued
Limits are valid for −40 °C ≤ T_mb ≤ +150 °C and typical values for T_mb = 25 °C unless otherwise specified.
Symbol Parameter
Conditions
Min Typ
∆V_BG(UV) hysteresis
Overvoltage ^[9]
-
0.5
V_BG(OV) high supply threshold voltage
[8] ₄₀
45
∆V_BG(OV) hysteresis
Overload protection ^[9]
-
1
I_L(lim)
limiting load current
Short circuit load protection ^[9][10]
V_BG ≥ 9 V; V_BL = V_BG; Figure 8
[10] ₁₂
18
V_BL(TO) battery load threshold voltage
V_BG = 16 V; Figure 11
[11] ₈
10
Overtemperature protection ^[9][10]
V_BG = 35 V
15 20
T_j(TO)
threshold junction temperature
[12] _{150 170}
∆T_j(TO) hysteresis
Status ^[5][9]
-
10
V_SG
status clamping voltage
I_S = 100 µA
5.5 7
V_SG
status low voltage
I_S = 100 µA; Figure 7
T_mb = −40 °C
-
-
T_mb = 25 °C
-
0.7
I_S
status leakage current
V_SG = 5 V
T_mb = 150 °C
-
-
R_S
external pull-up resistor
T_mb = 25 °C
V_SG = 5 V
-
0.1
[13] _-
47
Max
-
50
-
24
12
25
190
-
8.5
1
0.8
15
1
-
Unit
V
V
V
A
V
V
°C
°C
V
V
V
µA
µA
kΩ
[1] For a high-side switch, the load pin voltage goes negative with respect to ground during the turn-off of an inductive load.
[2] This is the current drawn from the supply when the input is LOW, and includes leakage current to the load.
[3] Defined as in ISO 10483-1. For comparison purposes only.
[4] The supply and input voltages for the R_BLon tests are continuous. The specified pulse duration is t_p = 300 µs, and refers only to the
applied load current.
[5] 9 V ≤ V_BG ≤ 16 V
[6] 9 V ≤ V_BG ≤ 35 V. A low current load can be detected in the on-state.
[7] Undervoltage sensor causes the device to switch off and reset.
[8] Overvoltage sensor causes the device to switch off to protect the load.
[9] See Table 3 “Truth table”
[10] 5.5 V ≤ V_BG ≤ 35 V
[11] The battery to load threshold voltage for short circuit is approximately proportional to the battery supply voltage.
[12] After cooling below the reset temperature the switch will resume normal operation.
[13] The status output is an open drain transistor and requires an external pull-up circuit to indicate a logic HIGH
9397 750 09384
Product data
Rev. 02 — 06 June 2002
© Koninklijke Philips Electronics N.V. 2002. All rights reserved.
6 of 16