TDA8596_15 Datasheet, PDF(1/48 Page) NXP Semiconductors – I2C-bus controlled 4 ´ 45 W power amplifier with symmetrical inputs

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

TDA8596_15 Datasheet, PDF (1/48 Pages) NXP Semiconductors – I2C-bus controlled 4 ´ 45 W power amplifier with symmetrical inputs

TDA8596

I2C-bus controlled 4 Ã 45 W power ampliï¬er with symmetrical

inputs

Rev. 02 â 8 November 2007

Product data sheet

1. General description

The TDA8596 is a quad Bridge Tied Load (BTL) audio power ampliï¬er with symmetrical

inputs, made in BCDMOS technology. It contains four independent ampliï¬er channels in

BTL conï¬guration with complementary (PMOST/NMOST) output stages. Temperature

warning and output signal clipping diagnosis is possible via the I2C-bus and via the

diagnostic pins (DIAG and STB pin). The temperature pre-warning level and clip detection

levels can be programmed via the I2C-bus. The status of each ampliï¬er channel (i.e.

output offset, load connected or not, short circuit condition at the output pins) can be read

out separately.

2. Features

2.1 General

I Operates in legacy mode (non I2C-bus) and I2C-bus mode (3.3 V and 5 V compliant)

I Three hardware-programmable I2C-bus addresses

I Drives 4 â¦ or 2 â¦ loads

I Balanced/symmetrical inputs

I Speaker fault detection

I Programmable gain (26 dB and 16 dB) also available in legacy mode

I Independent short circuit protection per channel

I Loss of ground and loss of VP safe (with 300 mâ¦ series impedance and a maximum

supply decoupling capacitor of 2200 ÂµF)

I All outputs are short-circuit proof to ground, supply voltage and across the load

I All pins are short circuit proof to ground

I Temperature-controlled gain reduction to prevent audio holes at high junction

temperatures

I Low battery voltage detection

I Qualiï¬ed in accordance with AEC-Q100

2.2 I2C-bus mode

I DC load detection: open (no load), normal load, line-driver load

I AC load (tweeter) detection

I Detect which load is connected during start-up to allow the system to be conï¬gured to

select the gain accordingly (e.g. line-driver mode or normal mode).

I Independently selectable soft mute of front (channel 1 and channel 3) and rear

channels (channel 2 and channel 4)

▷