DRQ-12-50-L48 Datasheet, PDF (4/26 Pages) Murata Power Solutions Inc. – 600W Digital Fully Regulated Intermediate DC-DC Bus Converter

FUNCTIONAL SPECIFICATIONS, (CONT.)
OUTPUT
Total Output Power
Voltage
Nominal Output Voltage
Setting Accuracy
Output Voltage
Overvoltage Protection
Current
Output Current Range
Minimum Load
Current Limit Inception
Short Circuit
Short Circuit Current
Short Circuit Duration
(remove short for recovery)
Short circuit protection method
Regulation ➄
Line Regulation
Load Regulation
Ripple and Noise ➅
Temperature Coefficient
Maximum Capacitive Loading
MECHANICAL (Through Hole Models)
Outline Dimensions with heat sink
(Please refer to outline drawing)
Outline Dimensions with baseplate
(Please refer to outline drawing)
Weight with heat sink
Conditions ➀
No trim, all conditions
At 50% load, no trim
@Vin=48V, Iout=0, Ta=+25°C
Via magnetic feedback
90% of Vout, after warmup
Hiccup technique, autorecovery within ±1.25%
of Vout
Output shorted to ground, no damage
Current limiting
Iout = min. to max.
5 Hz- 20 MHz BW
At all outputs
Low ESR
LxWxH
LxWxH
Weight with baseplate
Through Hole Pin Diameter
Through Hole Pin Material
TH Pin Plating Metal and Thickness
ENVIRONMENTAL
Operating Ambient Temperature Range
Operating Case Temperature
Storage Temperature
Thermal Protection/Shutdown
Electromagnetic Interference
Conducted, EN55022/CISPR22
RoHS rating
Nickel subplate
Gold overplate
See Derating
No derating
Vin = Zero (no power)
Measured in center
External filter is required
DRQ-12/50-L48 Series
600W Digital Fully Regulated
Intermediate DC-DC Bus Converter
Minimum
0
11.76
-2
11.95
13.8
0
56
Typical/Nominal
600
12
14.4
58
0.4
Continuous
Maximum
612
12.24
2
12.05
15.6
50
60
1
Units
W
Vdc
% of Vnom
Vdc
Vdc
A
A
A
40
100
mV
40
120
mV
150
200
mV pk-pk
±0.02
% of Vout./°C
10,000
μF
2.3 x 1.45 x 1.1
58.4 x 36.83 x 27.94
2.3 x 1.45 x .052
58.4x 36.83x 13.2
3.38
96
2.63
74.5
0.04 & 0.062
1.016 & 1.575
Copper alloy
98.4-299
4.7-19.6
Inches
mm
Inches
mm
Ounces
Grams
Ounces
Grams
Inches
mm
μ-inches
μ-inches
-40
85
°C
-40
110
°C
-55
125
°C
135
°C
B
Class
RoHS-6
Notes
➀ Unless otherwise noted, all specifications apply at Vin = nominal, nominal output voltage and full
output load. General conditions are near sea level altitude, no base plate installed and natural
convection airflow unless otherwise specified. All models are tested and specified with external
parallel 1 μF and 10 μF output capacitors (see Technical Notes). All capacitors are low-ESR types
wired close to the converter. These capacitors are necessary for our test equipment and may not
be needed in the user’s application.
➁ Input (back) ripple current is tested and specified over 5 Hz to 20 MHz bandwidth. Input filtering is
Cin = 33 μF/100V, Cbus = 220μF/100V and Lbus = 12 μH.
➂ All models are stable and regulate to specification under no load.
➃ The Remote On/Off Control is referred to -Vin.
➄ Regulation specifications describe the output voltage changes as the line voltage or load current
is varied from its nominal or midpoint value to either extreme. The load step is ±25% of full load
current.
➅ Output Ripple and Noise is measured with Cout = 1 μF || 10 μF, 20 MHz oscilloscope bandwidth
and full resistive load.
www.murata-ps.com/support
MDC_DRQ-12/50-L48NK.B02 Page 4 of 26