MT29F8G08ADADAH4D Datasheet, PDF (51/132 Pages) Micron Technology – 4Gb, 8Gb, 16Gb: x8, x16 NAND Flash Memory Features

Micron Confidential and Proprietary
4Gb, 8Gb, 16Gb: x8, x16 NAND Flash Memory
Feature Operations
GET FEATURES (EEh)
The GET FEATURES (EEh) command reads the subfeature parameters (P1–P4) from the
specified feature address. This command is accepted by the target only when all die
(LUNs) on the target are idle.
Writing EEh to the command register puts the target in get features mode. The target
stays in this mode until another valid command is issued.
When the EEh command is followed by a feature address, the target goes busy for ^tFEAT.
If the READ STATUS (70h) command is used to monitor for command completion, the
READ MODE (00h) command must be used to re-enable data output mode.
After ^tFEAT completes, the host enables data output mode to read the subfeature pa-
rameters.
Figure 31: GET FEATURES (EEh) Operation
Cycle type Command Address
D_OUT
D_OUT
D_OUT
D_OUT
I/Ox
EEh
FA
P1
P2
P3
P4
tWB
tFEAT tRR
R/B#
PDF: 09005aef83b25735
m60a_4gb_8gb_16gb_ecc_nand.pdf - Rev. N 10/12 EN
51
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2009 Micron Technology, Inc. All rights reserved.