English
Language : 

PIC16LF1946_13 Datasheet, PDF (56/478 Pages) Microchip Technology – 64-Pin Flash-Based, 8-Bit CMOS Microcontrollers with LCD Driver and nanoWatt XLP Technology
PIC16(L)F1946/1947
4.2 Register Definitions: Configuration Words
REGISTER 4-1:
CONFIG1: CONFIGURATION WORD 1
R/P-1
FCMEN
bit 13
R/P-1
IESO
R/P-1
CLKOUTEN
R/P-1
R/P-1
BOREN<1:0>
R/P-1
CPD
bit 8
R/P-1
CP
bit 7
R/P-1
MCLRE
R/P-1
PWRTE
R/P-1
R/P-1
WDTE<1:0>
R/P-1
R/P-1
FOSC<2:0>
R/P-1
bit 0
Legend:
R = Readable bit
‘0’ = Bit is cleared
P = Programmable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘1’
-n = Value when blank or after Bulk Erase
bit 13
bit 12
bit 11
bit 10-9
bit 8
bit 7
bit 6
bit 5
FCMEN: Fail-Safe Clock Monitor Enable bit
1 = Fail-Safe Clock Monitor is enabled
0 = Fail-Safe Clock Monitor is disabled
IESO: Internal External Switchover bit
1 = Internal/External Switchover mode is enabled
0 = Internal/External Switchover mode is disabled
CLKOUTEN: Clock Out Enable bit
If FOSC configuration bits are set to LP, XT, HS modes:
This bit is ignored, CLKOUT function is disabled. Oscillator function on the CLKOUT pin.
All other FOSC modes:
1 = CLKOUT function is disabled. I/O function on the CLKOUT pin.
0 = CLKOUT function is enabled on the CLKOUT pin
BOREN<1:0>: Brown-out Reset Enable bits(1)
11 = BOR enabled
10 = BOR enabled during operation and disabled in Sleep
01 = BOR controlled by SBOREN bit of the BORCON register
00 = BOR disabled
CPD: Data Code Protection bit(2)
1 = Data memory code protection is disabled
0 = Data memory code protection is enabled
CP: Code Protection bit(3)
1 = Program memory code protection is disabled
0 = Program memory code protection is enabled
MCLRE: MCLR/VPP Pin Function Select bit
If LVP bit = 1:
This bit is ignored.
If LVP bit = 0:
1 = MCLR/VPP pin function is MCLR; Weak pull-up enabled.
0 = MCLR/VPP pin function is digital input; MCLR internally disabled; Weak pull-up under control of
WPUG5 bit.
PWRTE: Power-up Timer Enable bit(1)
1 = PWRT disabled
0 = PWRT enabled
Note 1: Enabling Brown-out Reset does not automatically enable Power-up Timer.
2: The entire data EEPROM will be erased when the code protection is turned off during
3: The entire program memory will be erased when the code protection is turned off.
DS41414D-page 56
 2010-2012 Microchip Technology Inc.