PIC18LF2X Datasheet, PDF (33/44 Pages) Microchip Technology – 28/40/44-Pin, Low-Power, High-Performance Microcontrollers with XLP Technology

PIC18(L)F2X/4XK50
TABLE 5-3: PIC18(L)F2X/4XK50 BIT DESCRIPTIONS (CONTINUED)
Bit Name
Configuration
Words
Description
CP3
CONFIG5L Code Protection bits (Block 3 code memory area)
1 = Block 3 is not code-protected
0 = Block 3 is code-protected
CP2
CONFIG5L Code Protection bits (Block 2 code memory area)
1 = Block 2 is not code-protected
0 = Block 2 is code-protected
CP1
CONFIG5L Code Protection bits (Block 1 code memory area)
1 = Block 1 is not code-protected
0 = Block 1 is code-protected
CP0
CONFIG5L Code Protection bits (Block 0 code memory area)
1 = Block 0 is not code-protected
0 = Block 0 is code-protected
CPD
CONFIG5H Code Protection bits (Data EEPROM)
1 = Data EEPROM is not code-protected
0 = Data EEPROM is code-protected
CPB
CONFIG5H Code Protection bits (Boot Block memory area)
1 = Boot Block is not code-protected
0 = Boot Block is code-protected
WRT3
CONFIG6L
Write Protection bits (Block 3 code memory area)
1 = Block 3 is not write-protected
0 = Block 3 is write-protected
WRT2
CONFIG6L Write Protection bits (Block 2 code memory area)
1 = Block 2 is not write-protected
0 = Block 2 is write-protected
WRT1
CONFIG6L Write Protection bits (Block 1 code memory area)
1 = Block 1 is not write-protected
0 = Block 1 is write-protected
WRT0
CONFIG6L Write Protection bits (Block 0 code memory area)
1 = Block 0 is not write-protected
0 = Block 0 is write-protected
WRTD
CONFIG6H Write Protection bit (Data EEPROM)
1 = Data EEPROM is not write-protected
0 = Data EEPROM is write-protected
WRTB
CONFIG6H
Write Protection bit (Boot Block memory area)
1 = Boot Block is not write-protected
0 = Boot Block is write-protected
WRTC
CONFIG6H Write Protection bit (Configuration registers)
1 = Configuration registers are not write-protected
0 = Configuration registers are write-protected
Note 1: Minimum VDD for F devices is 2.3V.
2: When the 3x Multiplier mode is selected, the input frequency has to be 16 MHz. When the 4x Multiplier
mode is selected, the input frequency has to be between 8 MHz and 16 MHz.
3: The dedicated In-Circuit Port is available only on the 44-pin TQFP packaged devices. This bit should be
programmed to a ‘0’ in all other devices. See Section 2.2 “Dedicated ICSP/ICD Port (44-Pin TQFP
Only)” for more information.
 2012 Microchip Technology Inc.
DS41630B-page 33