PIC24FJ256GB106-I Datasheet, PDF (269/328 Pages) Microchip Technology – 64/80/100-Pin, 16-Bit Flash Microcontrollers with USB On-The-Go (OTG)

PIC24FJ256GB110 FAMILY
REGISTER 24-1: CTMUCON: CTMU CONTROL REGISTER
R/W-0
CTMUEN
bit 15
U-0
R/W-0
R/W-0
R/W-0
—
CTMUSIDL TGEN
EDGEN
R/W-0
EDGSEQEN
R/W-0
IDISSEN
R/W-0
CTTRIG
bit 8
R/W-0
EDG2POL
bit 7
R/W-0
EDG2SEL1
R/W-0
EDG2SEL0
R/W-0
EDG1POL
R/W-0
EDG1SEL1
R/W-0
EDG1SEL0
R/W-0
EDG2STAT
R/W-0
EDG1STAT
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13
bit 12
bit 10
bit 10
bit 9
bit 8
bit 7
bit 6-5
bit 4
CTMUEN: CTMU Enable bit
1 = Module is enabled
0 = Module is disabled
Unimplemented: Read as ‘0’
CTMUSIDL: Stop in Idle Mode bit
1 = Discontinue module operation when device enters Idle mode
0 = Continue module operation in Idle mode
TGEN: Time Generation Enable bit
1 = Enables edge delay generation
0 = Disables edge delay generation
EDGEN: Edge Enable bit
1 = Edges are not blocked
0 = Edges are blocked
EDGSEQEN: Edge Sequence Enable bit
1 = Edge 1 event must occur before Edge 2 event can occur
0 = No edge sequence is needed
IDISSEN: Analog Current Source Control bit
1 = Analog current source output is grounded
0 = Analog current source output is not grounded
CTTRIG: Trigger Control bit
1 = Trigger output is enabled
0 = Trigger output is disabled
EDG2POL: Edge 2 Polarity Select bit
1 = Edge 2 programmed for a positive edge response
0 = Edge 2 programmed for a negative edge response
EDG2SEL1:EDG2SEL0: Edge 2 Source Select bits
11 = CTED1 pin
10 = CTED2 pin
01 = OC1 module
00 = Timer1 module
EDG1POL: Edge 1 Polarity Select bit
1 = Edge 1 programmed for a positive edge response
0 = Edge 1 programmed for a negative edge response
© 2008 Microchip Technology Inc.
Preliminary
DS39897B-page 267