PIC24FV32KA304_1 Datasheet, PDF (249/320 Pages) Microchip Technology – 20/28/44/48-Pin, General Purpose, 16-Bit Flash Microcontrollers with XLP Technology

PIC24FV32KA304 FAMILY
The WDT, prescaler and postscaler are reset:
• On any device Reset
• On the completion of a clock switch, whether
invoked by software (i.e., setting the OSWEN bit
after changing the NOSC bits) or by hardware
(i.e., Fail-Safe Clock Monitor)
• When a PWRSAV instruction is executed
(i.e., Sleep or Idle mode is entered)
• When the device exits Sleep or Idle mode to
resume normal operation
• By a CLRWDT instruction during normal execution
If the WDT is enabled in hardware (FWDTEN<1:0> = 11),
it will continue to run during Sleep or Idle modes. When
the WDT time-out occurs, the device will wake and code
execution will continue from where the PWRSAV
instruction was executed. The corresponding SLEEP or
IDLE bits (RCON<3:2>) will need to be cleared in
software after the device wakes up.
The WDT Flag bit, WDTO (RCON<4>), is not
automatically cleared following a WDT time-out. To
detect subsequent WDT events, the flag must be
cleared in software.
Note:
The CLRWDT and PWRSAV instructions
clear the prescaler and postscaler counts
when executed.
26.3.1 WINDOWED OPERATION
The Watchdog Timer has an optional Fixed Window
mode of operation. In this Windowed mode, CLRWDT
instructions can only reset the WDT during the last 1/4
of the programmed WDT period. A CLRWDT instruction
executed before that window causes a WDT Reset,
similar to a WDT time-out.
Windowed WDT mode is enabled by programming the
Configuration bit, WINDIS (FWDT<6>), to ‘0’.
26.3.2 CONTROL REGISTER
The WDT is enabled or disabled by the FWDTEN<1:0>
Configuration bits. When both the FWDTEN<1:0> Con-
figuration bits are set, the WDT is always enabled.
The WDT can be optionally controlled in software when
the FWDTEN<1:0> Configuration bits have been pro-
grammed to ‘10’. The WDT is enabled in software by
setting the SWDTEN control bit (RCON<5>). The
SWDTEN control bit is cleared on any device Reset.
The software WDT option allows the user to enable the
WDT for critical code segments, and disable the WDT
during non-critical segments, for maximum power sav-
ings. When the FWTEN<1:0> bits are set to ‘01’, the
WDT is enabled only in Run and Idle modes, and is dis-
abled in Sleep. Software control of the WDT SWDTEN
bit (RCON<5>) is disabled with this setting.
FIGURE 26-2:
WDT BLOCK DIAGRAM
SWDTEN
FWDTEN
LPRC Input
All Device Resets
Transition to
New Clock Source
Exit Sleep or
Idle Mode
CLRWDT Instr.
PWRSAV Instr.
Sleep or Idle Mode
LPRC Control
FWPSA
31 kHz
Prescaler
(5-Bit/7-Bit)
WDT
Counter
1 ms/4 ms
WDTPS<3:0>
Postscaler
1:1 to 1:32.768
Wake from Sleep
WDT Overflow
Reset
 2011 Microchip Technology Inc.
DS39995B-page 249