PIC24FJ64GA006-I Datasheet, PDF (218/258 Pages) Microchip Technology – 64/80/100-Pin, General Purpose, 16-Bit Flash Microcontrollers

PIC24FJ128GA010 FAMILY
27.1 DC Characteristics
TABLE 27-1: OPERATING MIPS vs. VOLTAGE
VDD Range
(in Volts)
Temp Range
(in °C)
2.0-3.6V
-40°C to +85°C
Max MIPS
PIC24FJ128GA010 Family
16
TABLE 27-2: THERMAL OPERATING CONDITIONS
Rating
PIC24FJ128GA010 Family:
Operating Junction Temperature Range
Operating Ambient Temperature Range
Power Dissipation:
Internal Chip Power Dissipation:
PINT = VDD x (IDD –  IOH)
I/O Pin Power Dissipation:
PI/O =  ({VDD – VOH} x IOH) +  (VOL x IOL)
Maximum Allowed Power Dissipation
Symbol Min
TJ
-40
TA
-40
Typ Max Unit
—
+125
°C
—
+85
°C
PD
PINT + PI/O
W
PDMAX
(TJ – TA)/JA
W
TABLE 27-3: THERMAL PACKAGING CHARACTERISTICS
Characteristic
Symbol Typ Max Unit Notes
Package Thermal Resistance, 14x14x1 mm TQFP
JA
50
—
°C/W (Note 1)
Package Thermal Resistance, 12x12x1 mm TQFP
JA
69.4
—
°C/W (Note 1)
Package Thermal Resistance, 10x10x1 mm TQFP
JA
76.6
—
°C/W (Note 1)
Note 1: Junction to ambient thermal resistance, Theta-JA (JA) numbers are achieved by package simulations.
TABLE 27-4: DC TEMPERATURE AND VOLTAGE SPECIFICATIONS
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
Param
No.
Sym
Characteristic
Min
Typ⁽¹⁾ Max Units
Conditions
Operating Voltage
DC10 Supply Voltage
VDD
VBOR
—
3.6
V Regulator is enabled
VDD
VDDCORE
—
3.6
V Regulator is disabled
VDDCORE
2.0
—
2.75
V Regulator is disabled
DC12 VDR
RAM Data Retention
Voltage⁽²⁾
1.5
—
—
V
DC16 VPOR VDD Start Voltage
—
to Ensure Internal
Power-on Reset Signal
—
VSS
V
DC17 SVDD
VDD Rise Rate
to Ensure Internal
Power-on Reset Signal
0.05
—
— V/ms 0-3.3V in 0.1s
0-2.5V in 60 ms
DC18 VBOR
Brown-out Reset
Voltage⁽³⁾
1.9
2.2
2.5
V Regulator must be enabled
Note 1:
2:
3:
Data in “Typ” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only
and are not tested.
This is the limit to which VDD can be lowered without losing RAM data.
Device will operate normally until Brown-out reset occurs even though VDD may be below VDDMIN.
DS39747F-page 218
 2005-2012 Microchip Technology Inc.