PIC24FJ64GA006-I Datasheet, PDF (142/258 Pages) Microchip Technology – 64/80/100-Pin, General Purpose, 16-Bit Flash Microcontrollers

PIC24FJ128GA010 FAMILY
REGISTER 16-2: I2CxSTAT: I2Cx STATUS REGISTER
R-0, HSC R-0, HSC
U-0
ACKSTAT TRSTAT
—
bit 15
U-0
U-0
—
—
R/C-0, HSC R-0, HSC
BCL
GCSTAT
R-0, HSC
ADD10
bit 8
R/C-0, HSC
IWCOL
bit 7
R/C-0, HSC
I2COV
R-0, HSC
D/A
R/C-0, HSC R/C-0, HSC R-0, HSC
P
S
R/W
R-0, HSC
RBF
R-0, HSC
TBF
bit 0
Legend:
R = Readable bit
-n = Value at POR
HS = Hardware Settable bit
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
C = Clearable bit
HSC = Hardware Settable/Clearable bit
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13-11
bit 10
bit 9
bit 8
bit 7
bit 6
bit 5
bit 4
ACKSTAT: Acknowledge Status bit
1 = NACK is received from slave
0 = ACK is received from slave
Hardware is set or clear at the end of slave Acknowledge.
TRSTAT: Transmit Status bit (When operating as I²C master; applicable to master transmit operation.)
1 = Master transmit is in progress (8 bits + ACK)
0 = Master transmit is not in progress
Hardware is set at the beginning of master transmission. Hardware is clear at the end of slave Acknowledge.
Unimplemented: Read as ‘0’
BCL: Master Bus Collision Detect bit
1 = A bus collision has been detected during master operation
0 = No collision
Hardware is set at the detection of a bus collision.
GCSTAT: General Call Status bit
1 = General call address was received
0 = General call address was not received
Hardware is set when an address matches a general call address. Hardware is clear at Stop detection.
ADD10: 10-Bit Address Status bit
1 = 10-bit address was matched
0 = 10-bit address was not matched
Hardware is set at a match of the 2nd byte of a matched 10-bit address. Hardware is clear at Stop detection.
IWCOL: Write Collision Detect bit
1 = An attempt to write the I2CxTRN register failed because the I²C module is busy
0 = No collision
Hardware is set at an occurrence of a write to I2CxTRN while busy (cleared by software).
I2COV: Receive Overflow Flag bit
1 = A byte was received while the I2CxRCV register is still holding the previous byte
0 = No overflow
Hardware is set at an attempt to transfer I2CxRSR to I2CxRCV (cleared by software).
D/A: Data/Address bit (when operating as I²C slave)
1 = Indicates that the last byte received was data
0 = Indicates that the last byte received was device address
Hardware is clear at a device address match. Hardware is set after a transmission finishes or by
reception of a slave byte.
P: Stop bit
1 = Indicates that a Stop bit has been detected last
0 = Stop bit was not detected last
Hardware is set or clear when a Start, Repeated Start or Stop is detected.
DS39747F-page 142
 2005-2012 Microchip Technology Inc.