PIC16F684T-E Datasheet, PDF (142/192 Pages) Microchip Technology – 14-Pin, Flash-Based 8-Bit CMOS Microcontrollers with nanoWatt Technology

PIC16F684
TABLE 15-2: OSCILLATOR PARAMETERS
Standard Operating Conditions (unless otherwise stated)
Operating Temperature -40°C ≤ TA ≤ +125°C
Param
No.
Sym
Characteristic
Freq
Tolerance
Min
Typ†
Max
Units
Conditions
OS06 TWARM Internal Oscillator Switch
—
when running⁽³⁾
—
—
2
TOSC Slowest clock
OS07 TSC
Fail-Safe Sample Clock
—
Period⁽¹⁾
—
21
—
ms LFINTOSC/64
OS08
HFOSC Internal Calibrated
HFINTOSC Frequency⁽²⁾
±1%
±2%
7.92 8.0 8.08 MHz VDD = 3.5V, 25°C
7.84 8.0 8.16 MHz 2.5V ≤ VDD ≤ 5.5V,
0°C ≤ TA ≤ +85°C
±5%
7.60 8.0 8.40 MHz 2.0V ≤ VDD ≤ 5.5V,
-40°C ≤ TA ≤ +85°C (Ind.),
-40°C ≤ TA ≤ +125°C (Ext.)
OS09* LFOSC Internal Uncalibrated
LFINTOSC Frequency
—
15
31
45 kHz
OS10*
TIOSC
ST
HFINTOSC Oscillator
Wake-up from Sleep
Start-up Time
—
5.5
12
24
μs VDD = 2.0V, -40°C to +85°C
—
3.5
7
14
μs VDD = 3.0V, -40°C to +85°C
—
3
6
11
μs VDD = 5.0V, -40°C to +85°C
*
†
Note 1:
2:
3:
These parameters are characterized but not tested.
Data in ‘Typ’ column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Instruction cycle period (TCY) equals four times the input oscillator time base period. All specified values are
based on characterization data for that particular oscillator type under standard operating conditions with the
device executing code. Exceeding these specified limits may result in an unstable oscillator operation and/or
higher than expected current consumption. All devices are tested to operate at ‘min’ values with an external
clock applied to the OSC1 pin. When an external clock input is used, the ‘max’ cycle time limit is ‘DC’ (no clock)
for all devices.
To ensure these oscillator frequency tolerances, VDD and VSS must be capacitively decoupled as close to the
device as possible. 0.1 μF and 0.01 μF values in parallel are recommended.
By design.
DS41202F-page 140
© 2007 Microchip Technology Inc.