409-10039 Datasheet, PDF (8/15 Pages) Tyco Electronics – Micro Pneumatic Tooling

“Micro” Pneumatic Tooling Assembly 1490567- 1
409- 10039
Airflow
Filter and Moisture
Separator
Regulator
Lubricator
To Machine
DRAIN REGULARLY
CHECK AIR PRESSURE REGULARLY
(620 kPa [90 psi] Min—690 kPa [100 psi] Max)
CHECK OIL LEVEL REGULARLY
(Adjust to Very Fine Mist—Approximately
1 Drop per 15- 20 Tool Cycles)
D Minimizes clogging and excessive
wear
D Minimizes rust and corrosion
D Prevents water from washing
away lubricants
D Promotes smooth, consistent performance
D Protects hoses and components from
damage
D Eliminates sluggish or sticking valves and
pistons
D Provides protective film for highly polished
or close tolerance surfaces
D Provides seal in close tolerance areas
D Prevents water emission from
exhaust ports
D Extends life of pistons, cylinders, and
valves
SUGGESTED MANUFACTURERS
Filter/Moisture Separator, Regulator, Lubricator
Lubricator Oil
(Use Only Good Quality, Non- Synthetic Air Lubricant)
C.A. Norgen Co., Littleton, CO
Chicago Pneumatic Tool Co., New York, NY
(C.P. Airoilene SAE 10)
Chicago Pneumatic Tool Co., New York, NY
Figure 5
4. SYSTEM SETUP AND PREPARATION FOR OPERATION
As delivered, the system has all required air lines installed with the main air supply line ready for connection to
the main air supply. Perform the steps in this section for initial setup and any time a different cam and/or tool
holder assembly is to be used.
System setup includes the following general steps:
1. Making sure the power unit is not connected to the main air supply.
2. Assembling the proper cam to the power unit.
3. Assembling the tool holder assembly to the power unit, ensuring that the cam and tool holder
assembly are properly aligned.
4. Connecting the main air supply.
4.1. Air Supply
If the tool is connected to an air supply, disconnect the tool and make sure there is no residual pressure in the
tool.
4.2. Extending the Piston
If the piston is not extended, grasp the piston with the piston pliers and pull away from the body of the tool.
8 of 15
Tyco Electronics Corporation
Rev C