409-10039 Datasheet, PDF (13/15 Pages) Tyco Electronics – Micro Pneumatic Tooling

“Micro” Pneumatic Tooling Assembly 1490567- 1
409- 10039
3. Remove the stop ring by inserting the end of a flat blade screwdriver under the removal notch and
prying outward. Slide the stop ring off the front of the air cylinder.
CAUTION
!
Be careful when removing parts to prevent scarring on the outside surface of the cylinder.
4. Slide the locking collar off the front of the air cylinder.
5. Inspect the stop ring groove for wear or permanent deformation. If excessive wear or damage is
evident, refer to Paragraph 9.3 for information on obtaining customer repair service.
B. Installation
1. Using a caliper, measure the width of the stop ring groove. See Figure 8. Using this dimension, refer
to Figure 9 for the proper stop ring to be used.
2. Slide the locking collar onto the front of the air cylinder.
3. Slide the stop ring onto the front of the air cylinder and carefully seat the ring into the stop ring
groove. Do not deform the ring.
4. Install the friction ring.
5. Visually inspect the tooling assembly to assure that the locking collar, stop ring, and friction ring are
installed properly.
6. Using a caliper, measure the diameter of the stop ring. See Figure 8. Take measurements at several
different locations around the ring. If the measurements are within the tolerance (for the stop ring being
used) provided in Figure 9, the tooling assembly is considered dimensionally correct. If any of the
measurements are not within the tolerance, refer to Paragraph 9.3 for information on obtaining further
evaluation and repair.
Width of Stop
Ring Groove
Diameter of
Stop Ring
Figure 8
9.3. Repair
For customer repair service, please contact a Tyco Electronics Representative at 1--800--526--5136.
10. REVISION SUMMARY
Revisions to this customer manual include:
S Added “Original Instructions” to page 1
Rev C
Tyco Electronics Corporation
13 of 15