409-10039 Datasheet, PDF (3/15 Pages) Tyco Electronics – Micro Pneumatic Tooling

“Micro” Pneumatic Tooling Assembly 1490567- 1
Note: Basic “Micro” Pneumatic Tooling Systems consist of a power unit, a tool
holder assembly or adapter, a crimping head or adapter, and if required, a die set.
Tool Holder
Assemblies
Crimping
Heads/Adapters
Hand Actuated Power Unit
(Tooling Assembly)
1490567- 1 (Non- Logic)
409- 10039
SDE Adapter 1583527- 1
(Various Crimp Heads)
Small Tool Holder Assembly
1673611- 1 (Logic)
Pneumatic Series
Crimping Heads
Straight Action
Tool Holder Assembly
356304- 1 (Logic)
Straight Action Crimper
217200- 1 (Various Dies)
Straight Action
Crimping Head Adapter
(Various Crimping Heads)
“T”- HEAD* Crimper
Figure 1
1. INTRODUCTION
This manual provides information on the various configurations of the tooling assembly, available options,
accessories, and upgrade capabilities for “Micro” Pneumatic Tooling Assembly 1490567--1. The manual also
includes complete operation and maintenance information for the system. Since there is a wide variety of
crimping heads that may be used with the tooling assembly, specific information concerning the individual
crimping heads, such as wire preparation and crimping head installation and maintenance, is provided with the
instructions packaged with the individual crimping heads. For a complete list of the available crimping heads
(with associated adapters, if required), refer to Catalog 1654684.
Rev C
Tyco Electronics Corporation
3 of 15