409-10039 Datasheet, PDF (4/15 Pages) Tyco Electronics – Micro Pneumatic Tooling

“Micro” Pneumatic Tooling Assembly 1490567- 1
409- 10039
Read this manual thoroughly before operating any of the pneumatic tools. The performance of these tools will
depend largely upon the intelligent use of information contained in this manual. When reading this manual, pay
particular attention to DANGER, CAUTION, NOTE, and SAFETY statements.
DANGER ^{Denotes an imminent hazard which may result in moderate or severe injury.}
CAUTION
!
Denotes a condition which may result in product or equipment damage.
NOTE
i
Highlights special or important information.
NOTE
i
Measurements are in metric units [followed by U.S. customary units in brackets]. Illustrations are for identification only
and are not drawn to scale.
DANGER ^{This unit should only be operated by trained personnel.}
DANGER ^{If not using quick- disconnect fittings to connect the tool to the air supply, provide operators other means to easily}
disconnect the tool from the air supply.
Read and understand the entire manual before using the tool.
Always wear appropriate eye protection when using the tool.
Always wear appropriate hearing protection when using the tool.
Always disconnect the air and lockout the tool when not in use or when head or tool holder is detached.
2. DESCRIPTION
The “Micro” Pneumatic Tooling System designed to accept a wide variety of crimping heads for crimping
various types of terminals and splices onto wires ranging in size from 10 through 26 AWG.
The systems employ a unique modular design concept, wherein each system configuration contains the
(same) identical power unit. System variations are then achieved by expansion of the power unit to obtain the
4 of 15
Tyco Electronics Corporation
Rev C