X5643 Datasheet, PDF (5/19 Pages) Intersil Corporation – CPU Supervisor with 64Kbit SPI EEPROM

X5643, X5645
Figure 4. Sample V_TRIP Reset Circuit
4.7K
V_TRIP
Adj.
Program
NC
+
1
8
2
7
3 ^X5643/45 6
4
5
V_P
NC ^4.7K
RESET
NC
10K
10K
Reset V_TRIP
Test V_TRIP
Set V_TRIP
SPI SERIAL MEMORY
The memory portion of the device is a CMOS serial
EEPROM array with Intersil’s block lock protection.
The array is internally organized as x 8. The device
features a Serial Peripheral Interface (SPI) and soft-
ware protocol allowing operation on a simple four-wire
bus.
The device utilizes Intersil’s proprietary Direct Write^™
cell, providing a minimum endurance of 100,000
cycles and a minimum data retention of 100 years.
The device is designed to interface directly with the
synchronous Serial Peripheral Interface (SPI) of many
popular microcontroller families. It contains an 8-bit
instruction register that is accessed via the SI input,
with data being clocked in on the rising edge of SCK.
CS must be LOW during the entire operation.
All instructions (Table 1), addresses and data are trans-
ferred MSB first. Data input on the SI line is latched on
the first rising edge of SCK after CS goes LOW. Data is
output on the SO line by the falling edge of SCK. SCK is
static, allowing the user to stop the clock and then start
it again to resume operations where left off.
Write Enable Latch
The device contains a write enable latch. This latch
must be SET before a write operation is initiated. The
WREN instruction will set the latch and the WRDI
instruction will reset the latch (Figure 3). This latch is
automatically reset upon a power-up condition and
after the completion of a valid Write Cycle.
Status Register
The RDSR instruction provides access to the status regis-
ter. The status register may be read at any time, even dur-
ing a write cycle. The status register is formatted as
follows:
7
65 43210
WPEN FLB WD1 WD0 BL1 BL0 WEL WIP
The Write-In-Progress (WIP) bit is a volatile, read only
bit and indicates whether the device is busy with an
internal nonvolatile write operation. The WIP bit is read
using the RDSR instruction. When set to a “1”, a non-
volatile write operation is in progress. When set to a
“0”, no write is in progress.
Table 1. Instruction Set
Instruction Name
WREN
SFLB
WRDI/RFLB
RSDR
WRSR
READ
WRITE
Instruction Format*
0000 0110
0000 0000
0000 0100
0000 0101
0000 0001
0000 0011
0000 0010
Operation
Set the write enable latch (enable write operations)
Set flag bit
Reset the write enable latch/reset flag bit
Read status register
Write status register (watchdog, block lock, WPEN & flag bits)
Read data from memory array beginning at selected address
Write data to memory array beginning at selected address
Note: *Instructions are shown MSB in leftmost position. Instructions are transferred MSB first.
5
FN8135.1
July 18, 2005