X40410 Datasheet, PDF (15/24 Pages) Intersil Corporation – Dual Voltage Monitor with Intergrated CPU Supervisor

X40410, X40411, X40414, X40415
D.C. OPERATING CHARACTERISTICS (Continued)
(Over the recommended operating conditions unless otherwise specified)
Symbol
Parameter
Min. Typ.⁽⁴⁾ Max. Unit
Test Conditions
V_CC Supply
V_TRIP1(5) V_CC Trip Point Voltage Range
2.0
4.75
V
4.55
4.6
4.65
V X40410/11-A
4.35
4.4
4.45
V X40410/11-B
2.85
2.9
2.95
V X40410/11-C,
X40414/15-A&C
t_RPD2(6) V_TRIP2 to V2FAIL
Second Supply Monitor
2.55
2.6
2.65
V X40414/15-B
5
µS
I_V2
V2MON Current
V_TRIP2 V2MON Trip Point Voltage Range
1.7
0.9
15
µA
4.75
V X40410/11
3.5
V X40414/15
2.85
2.9
2.95
V X40410/11-A
2.55
2.6
2.65
V X40410/11-B
1.65
1.7
1.75
V X40410/11-C
1.25
1.3
1.35
V X40414/15-A&B
0.95
1.0
1.05
V X40414/15-C
Notes: (1) The device enters the Active state after any start, and remains active until: 9 clock cycles later if the Device Select Bits in the Slave
Address Byte are incorrect; 200ns after a stop ending a read operation; or t_WC after a stop ending a write operation.
(2) The device goes into Standby: 200ns after any stop, except those that initiate a high voltage write cycle; t_WC after a stop that initiates a
high voltage cycle; or 9 clock cycles after any start that is not followed by the correct Device Select Bits in the Slave Address Byte.
(3) V_IL Min. and V_IH Max. are for reference only and are not tested.
(4) At 25°C, V_CC = 5V.
(5) See Ordering Information for standard programming levels. For custom programmed levels, contact factory.
(6) Based on characterization data.
EQUIVALENT INPUT CIRCUIT FOR VxMON (x = 1, 2)
R
∆V
V_ref
VxMON
+
C
V_REF
–
Output Pin
t_RPDX = 5µs worst case
∆V = 100mV
CAPACITANCE
Symbol
Parameter
C_OUT(1)
Output Capacitance (SDA, RESET, RESET, V2FAIL,
WDO)
C_IN(1)
Input Capacitance (SCL)
Note: (1) This parameter is not 100% tested.
Max.
8
6
Unit
pF
pF
Test Conditions
V_OUT = 0V
V_IN = 0V
15
FN8116.0
March 28, 2005