IA80C152 Datasheet, PDF (22/32 Pages) InnovASIC, Inc – UNIVERSAL COMMUNICATIONS CONTROLLER

Page 22 of 32
IA80C152
Preliminary Data Sheet
UNIVERSAL COMMUNICATIONS CONTROLLER
Absolute Maximum Ratings
AC/DC Parameters
Ambient temperature under bias....................................-40°C to +85°C ⁽²⁾
Operating temperature… … … … … … … … … … ..… -40°C to +85°C
Storage temperature..................................… ...................-65°C to +150°C
Voltage on any pin to VSS.............................................-0.3 to (V_DD +0.3)
Power dissipation.................................................… ........391.1 mW (95°C, 16MHz, 15% Toggle)
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. Operating the
device beyond the conditions indicated in the “recommended operating conditions” section is not recommended. Operation
at the “absolute maximum ratings” may adversely affect device reliability.
Notes: Design, Static and Dynamic Timing Characterization in Progress.
Table 8: DC Characteristics
Symbol
V_IL
V_IL1
V_IH
V_IH1
V_OL
V_OL1
V_OH
V_OH1
I_IL
I_TL
I_LI
RRST
I_IH
I_DD
Parameter
Input Low Voltage
(All Except EAn, EBEN)
Input Low Voltage
(EAn, EBEN)
Input High Voltage
( Except XTAL1, RSTn)
Input High Voltage
( XTAL1 RSTn)
Output Low Voltage
(Ports 1, 2, 3, 4, 5, 6)
Output Low Voltage
(Ports 0, ALE.PSENn, EPSENn)
Output High Voltage
(Ports 1, 2, 3, 4, 5, 6, COMM9
ALE, PSENn, EPSENn)
Output High Voltage
(Port 0 in External
Bus Mode)
Logical 0 Input Current
(Ports 1, 2, 3, 4, 5, 6)
Logical 1 to 0
Transition Current
(Ports 1, 2, 3, 4, 5, 6)
Input Leakage
( Port 0, EAn)
Reset Pull-up Resistor
Logical 1 Input Current (EBEN)
Power Supply Current:
Active (16.5 MHz)
Idle(16.5 MHz)
Power Down Mode
Min
Typ
Max Unit
Test Conditions
V
V
V
V
V
V
V
V
V
V
µA
µA
µA
kΩ
µA
mA
mA
100
µA
(1)
Notes:
(1) Static Idd current is exclusive of input/output drive requirements and is measured with the clocks stopped and all inputs
tied to Vdd or Vss, configured to draw minimum current.
(2) The input and output parametric values in section VII-B, parts 1, 2, and 3, are directly related to ambient temperature and
DC supply voltage. A temperature or supply voltage range other than those specified in the Operating Conditions above will
affect these values and part performance is not guaranteed by innovASIC.
Copyright © 2000
innovASIC
[_________The End of Obsolescence™