TLE8262E Datasheet, PDF (76/93 Pages) Infineon Technologies AG – Universal System Basis Chip HERMES Rev. 1.0

TLE8262E
Serial Peripheral Interface
Table 16 Interrupt Register encoder (cont’d)¹⁾
CS Bit Name
Default Default
Value Value
(INPUT) (OUT)
Data Input
Data Output
Configuration select 001 (SBC Failure interrupt)
001 OTP_V_cc1µC
1
0
Interrupt enabled (1) disabled V_cc1µC temperature pre warning
(0) for temperature pre-warning (1)
OT_HSCAN
1
0
Interrupt enabled (1) disabled HS CAN temperature shutdown
(0) for temperature shutdown (1)
OT_V_cc2
1
0
Interrupt enabled (1) disabled V_cc2 temperature shutdown (1)
(0) for temperature shutdown
UV_V_cc3
1
0
Interrupt enabled (1) disabled Undervoltage detection on Vcc3
(0) for undervoltage detection (1)
or due to back to normal voltage
SPI Fail
1
0
Interrupt enabled (1) disabled SPI input corrupted data (1)
(0) for SPI corrupted data.
Reset
1
0
Interrupt enabled (1) disabled Reset (1)
(0) for reset information
(only in SBC Software
(only in SBC Software
Development Mode)
Development Mode)
Wrong WD set 1
0
Interrupt enabled (1) disabled Incorrect WD programming for
(0) for incorrect Watchdog
data output
setting
UV V_cc2
1
0
Interrupt enabled (1) disabled Under voltage detected at V_cc2
(0) for undervoltage detection at
V_cc2
I_CC3 > I_CC3max
1
0
Interrupt enable (1) disabled (0) Over current detected at V_cc3
for over current at V_cc3
Configuration select 010 (Communication failure interrupt)
010 CAN failure 1 n.a
0
CAN failure 0 1
0
Interrupt enabled (1) disabled CAN failure Refer to Table 17
(0) for CAN failure
CAN Bus
1
0
Interrupt enabled (1) disabled CAN bus failure detected (1)
(0) for CAN bus failure
LINx failure 1 n.a
0
LINx failure 0 1
0
Interrupt enabled (1) disabled LIN failure. Refer to Table 17
(0) for LIN failure
1) A value of 0 will set the SBC into the opposite state.
Data Sheet
76
Rev. 1.0, 2009-03-31