HYB25D256800BT Datasheet, PDF (14/29 Pages) Infineon Technologies AG – 256MBit Double Data Rata SDRAM

HYB25D256[800/160]BT(L)-[5/5A]
256MBit Double Data Rata SDRAM
Preliminary DDR400 Data Sheet Addendum
Commands
CommandsDeselect
The Deselect function prevents new commands from being executed by the DDR SDRAM. The DDR SDRAM
is effectively deselected. Operations already in progress are not affected.
No Operation (NOP)
The No Operation (NOP) command is used to perform a NOP to a DDR SDRAM. This prevents unwanted
commands from being registered during idle or wait states. Operations already in progress are not affected.
Mode Register Set
The mode registers are loaded via inputs A0-A12, BA0 and BA1. See mode register descriptions in the Reg-
ister Definition section. The Mode Register Set command can only be issued when all banks are idle and no
bursts are in progress. A subsequent executable command cannot be issued until t_MRD is met.
Active
The Active command is used to open (or activate) a row in a particular bank for a subsequent access. The
value on the BA0, BA1 inputs selects the bank, and the address provided on inputs A0-A12 selects the row.
This row remains active (or open) for accesses until a Precharge (or Read or Write with Auto Precharge) is
issued to that bank. A Precharge (or Read or Write with Auto Precharge) command must be issued and com-
pleted before opening a different row in the same bank.
Read
The Read command is used to initiate a burst read access to an active (open) row. The value on the BA0,
BA1 inputs selects the bank, and the address provided on inputs A0-Ai, Aj (where [i = 8, j = don’t care] for
x16, [i = 9, j = don’t care] for x8 and [i = 9, j = 11] for x4) selects the starting column location. The value on
input A10 determines whether or not Auto Precharge is used. If Auto Precharge is selected, the row being
accessed is precharged at the end of the Read burst; if Auto Precharge is not selected, the row remains open
for subsequent accesses.
Write
The Write command is used to initiate a burst write access to an active (open) row. The value on the BA0,
BA1 inputs selects the bank, and the address provided on inputs A0-Ai, Aj (where [i = 9, j = don’t care] for x8;
where [i = 9, j = 11] for x4) selects the starting column location. The value on input A10 determines whether or
not Auto Precharge is used. If Auto Precharge is selected, the row being accessed is precharged at the end
of the Write burst; if Auto Precharge is not selected, the row remains open for subsequent accesses. Input
data appearing on the DQs is written to the memory array subject to the DM input logic level appearing coin-
cident with the data. If a given DM signal is registered low, the corresponding data is written to memory; if the
DM signal is registered high, the corresponding data inputs are ignored, and a Write is not executed to that
byte/column location.
Precharge
The Precharge command is used to deactivate (close) the open row in a particular bank or the open row(s) in
all banks. The bank(s) will be available for a subsequent row access a specified time (t_RP) after the Precharge
command is issued. Input A10 determines whether one or all banks are to be precharged, and in the case
where only one bank is to be precharged, inputs BA0, BA1 select the bank. Otherwise BA0, BA1 are treated
as “Don’t Care.” Once a bank has been precharged, it is in the idle state and must be activated prior to any
Page 14 of 29
2003-01-10, V0.9