English
Language : 

HY29F080 Datasheet, PDF (33/38 Pages) Hynix Semiconductor – 8 Megabit (1M x 8), 5 Volt-only, Flash Memory
AC CHARACTERISTICS
HY29F080
Alternate CE# Controlled Erase/Program Operations
Parameter
JEDEC Std
tAVAV
tAVWL
tWLAX
tDVWH
tWHDX
tGHEL
tWLEL
tEHWH
tELEH
tEHEL
tWC
tAS
tAH
tDS
tDH
tGHEL
tWS
tWH
tCP
tCPH
Description
Write Cycle Time (Note 1)
Address Setup Time
Address Hold Time
Data Setup Time
Data Hold Time
Read Recovery Time Before Write
WE# Setup Time
WE# Hold Time
CE# Pulse Width
CE# Pulse Width High
tWHWH1 tWHWH1 Byte Programming Operation (Notes 1, 2, 3)
Chip Programming Operation (Notes 1, 2, 3, 5)
tWHWH2 tWHWH2 Sector Erase Operation (Notes 1, 2, 4)
tWHWH3 tWHWH3 Chip Erase Operation (Notes 1, 2, 4)
Erase and Program Cycle Endurance
Speed Option
Unit
- 70 - 90 - 12
Min
70 90 120 ns
Min
0
ns
Min
45 45 50 ns
Min
30 45 50 ns
Min
0
ns
Min
0
ns
Min
0
ns
Min
0
ns
Min
35 45 50 ns
Min
20
ns
Typ
7
µs
Max
300
µs
Typ
7.2
sec
Max
21.6
sec
Typ
1
sec
Max
8
sec
Typ
16
sec
Max
128
sec
Typ
1,000,000 cycles
Min
100,000
cycles
Notes:
1. Not 100% tested.
2. Typical program and erase times assume the following conditions: 25 °C, VCC = 5.0 volts, 100,000 cycles. In addition,
programming typicals assume a checkerboard pattern. Maximum program and erase times are under worst case condi-
tions of 90 °C, V = 4.5 volts, 100,000 cycles.
CC
3. Excludes system-level overhead, which is the time required to execute the four-bus-cycle sequence for the program
command. See Table 5 for further information on command sequences.
4. Excludes 0x00 programming prior to erasure. In the preprogramming step of the Automatic Erase algorithm, all bytes
are programmed to 0x00 before erasure.
5. The typical chip programming time is considerably less than the maximum chip programming time listed since most
bytes program faster than the maximum programming times specified. The device sets DQ[5] = 1 only If the maximum
byte program time specified is exceeded. See Write Operation Status section for additional information.
Rev. 6.1/May 01
33